CONFIG_ARM=y
CONFIG_ARCH_MX6=y
CONFIG_SPL_GPIO_SUPPORT=y
CONFIG_SPL_LIBCOMMON_SUPPORT=y
CONFIG_SPL_LIBGENERIC_SUPPORT=y
CONFIG_TARGET_DISPLAY5=y
CONFIG_SPL_SERIAL_SUPPORT=y
CONFIG_SPL_SPI_FLASH_SUPPORT=y
CONFIG_SPL_SPI_SUPPORT=y
CONFIG_FIT=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=arch/arm/mach-imx/spl_sd.cfg,MX6Q"
CONFIG_BOOTDELAY=3
CONFIG_USE_BOOTCOMMAND=y
CONFIG_BOOTCOMMAND="run factory"
CONFIG_SPL=y
# CONFIG_SPL_RAW_IMAGE_SUPPORT is not set
# CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set
CONFIG_SPL_DMA_SUPPORT=y
CONFIG_SPL_I2C_SUPPORT=y
CONFIG_SPL_OS_BOOT=y
CONFIG_SPL_USB_HOST_SUPPORT=y
CONFIG_SPL_USB_GADGET_SUPPORT=y
CONFIG_SPL_USB_SDP_SUPPORT=y
CONFIG_HUSH_PARSER=y
CONFIG_SYS_PROMPT="display5 factory > "
CONFIG_CMD_BOOTZ=y
# CONFIG_CMD_ELF is not set
CONFIG_CMD_ASKENV=y
CONFIG_CRC32_VERIFY=y
CONFIG_CMD_EEPROM=y
CONFIG_CMD_DFU=y
# CONFIG_CMD_FPGA is not set
CONFIG_CMD_GPIO=y
CONFIG_CMD_GPT=y
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
CONFIG_CMD_PART=y
CONFIG_CMD_SF=y
CONFIG_CMD_SPI=y
CONFIG_CMD_USB_SDP=y
CONFIG_CMD_DHCP=y
CONFIG_CMD_MII=y
CONFIG_CMD_PING=y
CONFIG_CMD_CACHE=y
CONFIG_CMD_TIME=y
CONFIG_CMD_EXT2=y
CONFIG_CMD_EXT4=y
CONFIG_CMD_EXT4_WRITE=y
CONFIG_CMD_FAT=y
CONFIG_CMD_FS_GENERIC=y
CONFIG_CMD_MTDPARTS=y
CONFIG_MTDIDS_DEFAULT="nor0=02008000.spi.1"
CONFIG_MTDPARTS_DEFAULT="mtdparts=02008000.spi.1:128k(SPL),1m(u-boot),64k(env1),64k(env2),8m(lin-recovery),4m(swu-kernel),8m(swu-initramfs),-(reserved)"
# CONFIG_SPL_EFI_PARTITION is not set
CONFIG_PARTITION_TYPE_GUID=y
CONFIG_ENV_IS_IN_SPI_FLASH=y
CONFIG_DFU_MMC=y
CONFIG_DFU_SF=y
CONFIG_SPI_FLASH=y
CONFIG_SPI_FLASH_BAR=y
CONFIG_SPI_FLASH_SPANSION=y
CONFIG_SPI_FLASH_STMICRO=y
CONFIG_PHYLIB=y
CONFIG_NETDEVICES=y
CONFIG_FEC_MXC=y
# CONFIG_SPL_DM_SERIAL is not set
CONFIG_MXC_UART=y
CONFIG_USB=y
CONFIG_USB_GADGET=y
CONFIG_USB_GADGET_MANUFACTURER="Liebherr"
CONFIG_USB_GADGET_VENDOR_NUM=0x1b67
CONFIG_USB_GADGET_PRODUCT_NUM=0x4000
CONFIG_CI_UDC=y
CONFIG_USB_GADGET_DOWNLOAD=y
CONFIG_OF_LIBFDT=y