Synopsys DesignWare AMBA 2.0 Synchronous Serial Interface
and Synopsys DesignWare High Performance Synchronous Serial Interface

Required properties:
- compatible : One of
  "altr,socfpga-spi",
  "altr,socfpga-arria10-spi",
  "canaan,kendryte-k210-spi",
  "canaan,kendryte-k210-ssi",
  "intel,stratix10-spi",
  "intel,agilex-spi",
  "mscc,ocelot-spi",
  or "mscc,jaguar2-spi";
  and one of
  "snps,dw-apb-ssi-3.20a",
  "snps,dw-apb-ssi-3.22a",
  "snps,dw-apb-ssi-3.23",
  "snps,dw-apb-ssi-4.00a",
  "snps,dw-apb-ssi-4.01",
  or "snps,dwc-ssi-1.01a".
  "snps,dw-apb-ssi" may also be used, but is deprecated in favor of specific
  version strings.
- reg : The register base for the controller. For "mscc,<soc>-spi", a second
  register set is required (named ICPU_CFG:SPI_MST)
- #address-cells : <1>, as required by generic SPI binding.
- #size-cells : <0>, also as required by generic SPI binding.
- clocks : phandles for the clocks, see the description of clock-names below.
   The phandle for the "ssi_clk" is required. The phandle for the "pclk" clock
   is optional. If a single clock is specified but no clock-name, it is the
   "ssi_clk" clock. If both clocks are listed, the "ssi_clk" must be first.

Optional properties:
- clock-names : Contains the names of the clocks:
    "ssi_clk", for the core clock used to generate the external SPI clock.
    "pclk", the interface clock, required for register access.
- cs-gpios : Specifies the gpio pins to be used for chipselects.
- num-cs : The number of chipselects. If omitted, this will default to 4.
- reg-io-width : The I/O register width (in bytes) implemented by this
  device.  Supported values are 2 or 4 (the default).

Child nodes as per the generic SPI binding.

Example:

	spi@fff00000 {
		compatible = "altr,socfpga-arria10-spi",
			     "snps,dw-apb-ssi-4.00a", "snps,dw-apb-ssi";
		reg = <0xfff00000 0x1000>;
		interrupts = <0 154 4>;
		#address-cells = <1>;
		#size-cells = <0>;
		clocks = <&spi_m_clk>;
		num-cs = <2>;
		cs-gpios = <&gpio0 13 0>,
			   <&gpio0 14 0>;
	};