CONFIG_ARM=y
CONFIG_ARCH_CPU_INIT=y
CONFIG_ARCH_AT91=y
CONFIG_SYS_TEXT_BASE=0x20f00000
CONFIG_TARGET_VINCO=y
CONFIG_ENV_SIZE=0x10000
CONFIG_ENV_OFFSET=0x10000
CONFIG_ENV_SECT_SIZE=0x1000
CONFIG_NR_DRAM_BANKS=1
CONFIG_ENV_VARS_UBOOT_CONFIG=y
CONFIG_SPI_BOOT=y
CONFIG_BOOTDELAY=3
CONFIG_USE_BOOTARGS=y
CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk rw root=/dev/mmcblk0p2 rootfstype=ext4 rootwait quiet lpj=1990656"
# CONFIG_DISPLAY_BOARDINFO is not set
CONFIG_BOARD_EARLY_INIT_F=y
CONFIG_HUSH_PARSER=y
CONFIG_SYS_PROMPT="vinco => "
CONFIG_CMD_BOOTZ=y
# CONFIG_CMD_IMI is not set
CONFIG_CMD_GPT=y
# CONFIG_CMD_LOADS is not set
CONFIG_CMD_MMC=y
CONFIG_CMD_SF=y
CONFIG_CMD_USB=y
CONFIG_CMD_DHCP=y
CONFIG_CMD_MII=y
CONFIG_CMD_PING=y
CONFIG_CMD_FAT=y
CONFIG_OF_CONTROL=y
CONFIG_DEFAULT_DEVICE_TREE="at91-vinco"
CONFIG_ENV_IS_IN_SPI_FLASH=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_AT91_GPIO=y
CONFIG_SUPPORT_EMMC_BOOT=y
CONFIG_SPI_FLASH=y
CONFIG_SF_DEFAULT_MODE=0
CONFIG_SF_DEFAULT_SPEED=50000000
CONFIG_PHY_SMSC=y
CONFIG_ETH_DESIGNWARE=y
CONFIG_ATMEL_USART=y
CONFIG_USB=y
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_STORAGE=y
CONFIG_USB_GADGET=y
CONFIG_USB_GADGET_MANUFACTURER="L+G VInCo"
CONFIG_USB_GADGET_ATMEL_USBA=y
CONFIG_USB_ETHER=y
CONFIG_USB_HOST_ETHER=y
CONFIG_USB_ETHER_SMSC95XX=y