CONFIG_ARM=y
CONFIG_SYS_THUMB_BUILD=y
CONFIG_ARCH_VF610=y
CONFIG_SYS_TEXT_BASE=0x3f401000
CONFIG_ENV_SIZE=0x2000
CONFIG_ENV_OFFSET=0xA0000
CONFIG_NR_DRAM_BANKS=1
CONFIG_TARGET_PCM052=y
CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=board/phytec/pcm052/imximage.cfg"
CONFIG_BOOTDELAY=3
CONFIG_BOARD_EARLY_INIT_F=y
CONFIG_HUSH_PARSER=y
CONFIG_CMD_BOOTZ=y
CONFIG_CMD_MEMTEST=y
CONFIG_CMD_GPIO=y
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
CONFIG_CMD_NAND_TRIMFFS=y
CONFIG_CMD_DHCP=y
CONFIG_CMD_MII=y
CONFIG_CMD_PING=y
CONFIG_CMD_FAT=y
CONFIG_MTDIDS_DEFAULT="nand0=NAND"
CONFIG_MTDPARTS_DEFAULT="mtdparts=NAND:640k(bootloader),128k(env1),128k(env2),128k(dtb),6144k(kernel),-(root)"
CONFIG_CMD_UBI=y
CONFIG_OF_CONTROL=y
CONFIG_DEFAULT_DEVICE_TREE="vf610-pcm052"
CONFIG_ENV_IS_IN_NAND=y
CONFIG_SYS_REDUNDAND_ENVIRONMENT=y
CONFIG_ENV_OFFSET_REDUND=0xC0000
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_DM=y
CONFIG_DM_GPIO=y
CONFIG_VYBRID_GPIO=y
CONFIG_DM_I2C=y
CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
CONFIG_I2C_DEFAULT_BUS_NUMBER=0x2
CONFIG_SYS_I2C_MXC=y
CONFIG_MISC=y
CONFIG_I2C_EEPROM=y
CONFIG_SYS_I2C_EEPROM_ADDR=0x50
CONFIG_SYS_I2C_EEPROM_BUS=2
CONFIG_SYS_EEPROM_SIZE=32768
CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=6
CONFIG_SYS_I2C_EEPROM_ADDR_LEN=2
CONFIG_DM_MMC=y
CONFIG_FSL_ESDHC_IMX=y
CONFIG_MTD=y
CONFIG_DM_MTD=y
CONFIG_NAND_VF610_NFC=y
CONFIG_NAND_VF610_NFC_DT=y
CONFIG_SYS_NAND_BUSWIDTH_16BIT=y
CONFIG_DM_SPI_FLASH=y
CONFIG_SPI_FLASH_STMICRO=y
CONFIG_SPI_FLASH_MTD=y
CONFIG_PHYLIB=y
CONFIG_PHY_MICREL=y
CONFIG_PHY_MICREL_KSZ8XXX=y
CONFIG_DM_ETH=y
CONFIG_FEC_MXC=y
CONFIG_MII=y
CONFIG_PINCTRL=y
CONFIG_PINCTRL_VYBRID=y
CONFIG_DM_RTC=y
CONFIG_RTC_M41T62=y
CONFIG_DM_SERIAL=y
CONFIG_FSL_LPUART=y
CONFIG_SPI=y
CONFIG_DM_SPI=y
CONFIG_FSL_QSPI=y
# CONFIG_EFI_LOADER is not set