// SPDX-License-Identifier: GPL-2.0+
/*
 * Marvell / Cavium Inc. CN73xx
 */

/dts-v1/;

#include <dt-bindings/clock/octeon-clock.h>

/ {
	#address-cells = <2>;
	#size-cells = <2>;

	soc0: soc@0 {
		interrupt-parent = <&ciu3>;
		compatible = "simple-bus";
		#address-cells = <2>;
		#size-cells = <2>;
		ranges; /* Direct mapping */

		ciu3: interrupt-controller@1010000000000 {
			compatible = "cavium,octeon-7890-ciu3";
			interrupt-controller;
			/*
			 * Interrupts are specified by two parts:
			 * 1) Source number (20 significant bits)
			 * 2) Trigger type: (4 == level, 1 == edge)
			 */
			#address-cells = <0>;
			#interrupt-cells = <2>;
			reg = <0x10100 0x00000000 0x0 0xb0000000>;
		};

		bootbus: bootbus@1180000000000 {
			compatible = "cavium,octeon-3860-bootbus","simple-bus";
			reg = <0x11800 0x00000000 0x0 0x200>;
			/* The chip select number and offset */
			#address-cells = <2>;
			/* The size of the chip select region */
			#size-cells = <1>;
		};

		clk: clock {
			compatible = "mrvl,octeon-clk";
			#clock-cells = <1>;
			u-boot,dm-pre-reloc;
		};

		gpio: gpio-controller@1070000000800 {
			#gpio-cells = <2>;
			compatible = "cavium,octeon-7890-gpio";
			reg = <0x10700 0x00000800 0x0 0x100>;
			gpio-controller;
			nr-gpios = <32>;
			/* Interrupts are specified by two parts:
			 * 1) GPIO pin number (0..15)
			 * 2) Triggering (1 - edge rising
			 *		  2 - edge falling
			 *		  4 - level active high
			 *		  8 - level active low)
			 */
			interrupt-controller;
			#interrupt-cells = <2>;
			/* The GPIO pins connect to 16 consecutive CUI bits */
			interrupts = <0x03000 4>, <0x03001 4>,
				     <0x03002 4>, <0x03003 4>,
				     <0x03004 4>, <0x03005 4>,
				     <0x03006 4>, <0x03007 4>,
				     <0x03008 4>, <0x03009 4>,
				     <0x0300a 4>, <0x0300b 4>,
				     <0x0300c 4>, <0x0300d 4>,
				     <0x0300e 4>, <0x0300f 4>;
		};

		l2c: l2c@1180080000000 {
			#address-cells = <1>;
			#size-cells = <0>;
			compatible = "cavium,octeon-7xxx-l2c";
			reg = <0x11800 0x80000000 0x0 0x01000000>;
			u-boot,dm-pre-reloc;
		};

		lmc: lmc@1180088000000 {
			#address-cells = <1>;
			#size-cells = <0>;
			compatible = "cavium,octeon-7xxx-ddr4";
			reg = <0x11800 0x88000000 0x0 0x02000000>; // 2 IFs
			u-boot,dm-pre-reloc;
			l2c-handle = <&l2c>;
		};

		reset: reset@1180006001600 {
			compatible = "mrvl,cn7xxx-rst";
			reg = <0x11800 0x06001600 0x0 0x200>;
		};

		uart0: serial@1180000000800 {
			compatible = "cavium,octeon-3860-uart","ns16550";
			reg = <0x11800 0x00000800 0x0 0x400>;
			clocks = <&clk OCTEON_CLK_IO>;
			clock-frequency = <0>;
			current-speed = <115200>;
			reg-shift = <3>;
			interrupts = <0x08000 4>;
		};

		uart1: serial@1180000000c00 {
			compatible = "cavium,octeon-3860-uart","ns16550";
			reg = <0x11800 0x00000c00 0x0 0x400>;
			clocks = <&clk OCTEON_CLK_IO>;
			clock-frequency = <0>;
			current-speed = <115200>;
			reg-shift = <3>;
			interrupts = <0x08040 4>;
		};

		i2c0: i2c@1180000001000 {
			#address-cells = <1>;
			#size-cells = <0>;
			compatible = "cavium,octeon-7890-twsi";
			reg = <0x11800 0x00001000 0x0 0x200>;
			/* INT_ST, INT_TS, INT_CORE */
			interrupts = <0x0b000 1>, <0x0b001 1>, <0x0b002 1>;
			clock-frequency = <100000>;
			clocks = <&clk OCTEON_CLK_IO>;
		};

		i2c1: i2c@1180000001200 {
			#address-cells = <1>;
			#size-cells = <0>;
			compatible = "cavium,octeon-7890-twsi";
			reg = <0x11800 0x00001200 0x0 0x200>;
			/* INT_ST, INT_TS, INT_CORE */
			interrupts = <0x0b100 1>, <0x0b101 1>, <0x0b102 1>;
			clock-frequency = <100000>;
			clocks = <&clk OCTEON_CLK_IO>;
		};

		mmc: mmc@1180000002000 {
			compatible = "cavium,octeon-7890-mmc",
				     "cavium,octeon-7360-mmc";
			reg = <0x11800 0x00000000 0x0 0x2100>;
			#address-cells = <1>;
			#size-cells = <0>;
			/* EMM_INT_BUF_DONE,
			   EMM_INT_CMD_DONE,
			   EMM_INT_DMA_DONE,
			   EMM_INT_CMD_ERR,
			   EMM_INT_DMA_ERR,
			   EMM_INT_SWITCH_DONE,
			   EMM_INT_SWITCH_ERR,
			   EMM_DMA_DONE,
			   EMM_DMA_FIFO*/
			interrupts = <0x09040 1>,
				     <0x09041 1>,
				     <0x09042 1>,
				     <0x09043 1>,
				     <0x09044 1>,
				     <0x09045 1>,
				     <0x09046 1>,
				     <0x09000 1>,
				     <0x09001 1>;
			clocks = <&clk OCTEON_CLK_IO>;
		};

		spi: spi@1070000001000 {
			compatible = "cavium,octeon-3010-spi";
			reg = <0x10700 0x00001000 0x0 0x100>;
			interrupts = <0x05001 1>;
			#address-cells = <1>;
			#size-cells = <0>;
			spi-max-frequency = <25000000>;
			clocks = <&clk OCTEON_CLK_IO>;
		};

		/* USB 0 */
		usb0: uctl@1180068000000 {
			compatible = "cavium,octeon-7130-usb-uctl";
			reg = <0x11800 0x68000000 0x0 0x100>;
			ranges; /* Direct mapping */
			#address-cells = <2>;
			#size-cells = <2>;
			/* Only 100MHz allowed */
			refclk-frequency = <100000000>;
			/* Only "dlmc_ref_clk0" is supported for 73xx */
			refclk-type-ss = "dlmc_ref_clk0";
			/* Only "dlmc_ref_clk0" is supported for 73xx */
			refclk-type-hs = "dlmc_ref_clk0";

			/*
			 * Power is specified by three parts:
			 * 1) GPIO handle (must be &gpio)
			 * 2) GPIO pin number
			 * 3) Active high (0) or active low (1)
			 */
			xhci@1680000000000 {
				compatible = "cavium,octeon-7130-xhci","synopsys,dwc3","snps,dwc3";
				reg = <0x16800 0x00000000 0x10 0x0>;
				interrupts = <0x68080 4>; /* UAHC_IMAN, level */
				maximum-speed = "super-speed";
				dr_mode = "host";
				snps,dis_u3_susphy_quirk;
				snps,dis_u2_susphy_quirk;
				snps,dis_enblslpm_quirk;
			};
		};

		/* USB 1 */
		usb1: uctl@1180069000000 {
			compatible = "cavium,octeon-7130-usb-uctl";
			reg = <0x11800 0x69000000 0x0 0x100>;
			ranges; /* Direct mapping */
			#address-cells = <2>;
			#size-cells = <2>;
			/* 50MHz, 100MHz and 125MHz allowed */
			refclk-frequency = <100000000>;
			/* Either "dlmc_ref_clk0" or "dlmc_ref_clk0" */
			refclk-type-ss = "dlmc_ref_clk0";
			/* Either "dlmc_ref_clk0" "dlmc_ref_clk1" or "pll_ref_clk" */
			refclk-type-hs = "dlmc_ref_clk0";

			/*
			 * Power is specified by three parts:
			 * 1) GPIO handle (must be &gpio)
			 * 2) GPIO pin number
			 * 3) Active high (0) or active low (1)
			 */
			xhci@1690000000000 {
				compatible = "cavium,octeon-7130-xhci","synopsys,dwc3","snps,dwc3";
				reg = <0x16900 0x00000000 0x10 0x0>;
				interrupts = <0x69080 4>; /* UAHC_IMAN, level */
				dr_mode = "host";
			};
		};

		/* PCIe 0 */
		pcie0: pcie@1180069000000 {
			compatible =  "marvell,pcie-host-octeon";
			reg = <0 0xf2600000 0 0x10000>;
			#address-cells = <3>;
			#size-cells = <2>;
			device_type = "pci";
			dma-coherent;

			bus-range = <0 0xff>;
			marvell,pcie-port = <0>;
			ranges = <0x81000000 0x00000000 0xd0000000 0x00011a00 0xd0000000 0x00000000 0x01000000 /* IO */
				  0x02000000 0x00000000 0xe0000000 0x00011b00 0xe0000000 0x00000000 0x10000000	/* non-prefetchable memory */
				  0x43000000 0x00011c00 0x00000000 0x00011c00 0x00000000 0x00000010 0x00000000>;/* prefetchable memory */
		};

		uctl@118006c000000 {
			compatible = "cavium,octeon-7130-sata-uctl", "simple-bus";
			reg = <0x11800 0x6c000000 0x0 0x100>;
			ranges; /* Direct mapping */
			#address-cells = <2>;
			#size-cells = <2>;
			portmap = <0x3>;
			staggered-spinup;
			cavium,qlm-trim = "4,sata";

			sata: sata@16c0000000000 {
				compatible = "cavium,octeon-7130-ahci";
				reg = <0x16c00 0x00000000 0x0 0x200>;
				#address-cells = <2>;
				#size-cells = <2>;
				interrupts = <0x6c010 4>;
			};
		};
	};
};