CONFIG_ARM=y
CONFIG_COUNTER_FREQUENCY=25000000
CONFIG_TARGET_LS1043ARDB=y
CONFIG_TEXT_BASE=0x82000000
CONFIG_SYS_MALLOC_LEN=0x102000
CONFIG_SPL_LIBCOMMON_SUPPORT=y
CONFIG_SPL_LIBGENERIC_SUPPORT=y
CONFIG_NR_DRAM_BANKS=2
CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y
CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0x1000fff0
CONFIG_ENV_SIZE=0x2000
CONFIG_ENV_OFFSET=0x300000
CONFIG_SYS_I2C_MXC_I2C1=y
CONFIG_SYS_I2C_MXC_I2C2=y
CONFIG_SYS_I2C_MXC_I2C3=y
CONFIG_SYS_I2C_MXC_I2C4=y
CONFIG_DM_GPIO=y
CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1043a-rdb"
CONFIG_SPL_TEXT_BASE=0x10000000
CONFIG_FSL_LS_PPA=y
CONFIG_SYS_MONITOR_LEN=1048576
CONFIG_SPL_MMC=y
CONFIG_SPL_SERIAL=y
CONFIG_SPL_DRIVERS_MISC=y
CONFIG_SPL_STACK=0x1001e000
CONFIG_SPL=y
CONFIG_PCI=y
CONFIG_OF_BOARD_FIXUP=y
CONFIG_LAYERSCAPE_NS_ACCESS=y
CONFIG_PCIE1=y
CONFIG_PCIE2=y
CONFIG_PCIE3=y
CONFIG_REMAKE_ELF=y
CONFIG_MP=y
CONFIG_FIT_VERBOSE=y
CONFIG_RAMBOOT_PBL=y
CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1043ardb/ls1043ardb_pbi.cfg"
CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1043ardb/ls1043ardb_rcw_sd.cfg"
CONFIG_DISTRO_DEFAULTS=y
CONFIG_SD_BOOT=y
CONFIG_BOOTDELAY=10
CONFIG_OF_BOARD_SETUP=y
CONFIG_USE_BOOTARGS=y
CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 mtdparts=60000000.nor:2m@0x100000(nor_bank0_uboot),40m@0x1100000(nor_bank0_fit),7m(nor_bank0_user),2m@0x4100000(nor_bank4_uboot),40m@0x5100000(nor_bank4_fit),-(nor_bank4_user);7e800000.flash:1m(nand_uboot),1m(nand_uboot_env),20m(nand_fit);spi0.0:1m(uboot),5m(kernel),1m(dtb),9m(file_system)"
CONFIG_BOOTCOMMAND="run distro_bootcmd; run sd_bootcmd; env exists secureboot && esbc_halt;"
CONFIG_ARCH_MISC_INIT=y
CONFIG_MISC_INIT_R=y
CONFIG_SPL_MAX_SIZE=0x17000
CONFIG_SPL_PAD_TO=0x1d000
CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
CONFIG_SPL_BSS_START_ADDR=0x8f000000
CONFIG_SPL_BSS_MAX_SIZE=0x80000
CONFIG_SPL_FSL_PBL=y
CONFIG_SPL_BOARD_INIT=y
# CONFIG_SPL_SHARES_INIT_SP_ADDR is not set
CONFIG_SYS_SPL_MALLOC=y
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xf0
CONFIG_SPL_ENV_SUPPORT=y
CONFIG_SPL_MPC8XXX_INIT_DDR=y
CONFIG_SPL_WATCHDOG=y
CONFIG_SYS_MAXARGS=64
CONFIG_SYS_PBSIZE=532
CONFIG_CMD_IMLS=y
CONFIG_CMD_SPL=y
CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
CONFIG_CMD_DM=y
CONFIG_CMD_GPIO=y
CONFIG_CMD_GPT=y
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
CONFIG_CMD_NAND=y
CONFIG_CMD_USB=y
CONFIG_CMD_CACHE=y
CONFIG_MTDPARTS_DEFAULT="mtdparts=60000000.nor:2m@0x100000(nor_bank0_uboot),40m@0x1100000(nor_bank0_fit),7m(nor_bank0_user),2m@0x4100000(nor_bank4_uboot),40m@0x5100000(nor_bank4_fit),-(nor_bank4_user);7e800000.flash:1m(nand_uboot),1m(nand_uboot_env),20m(nand_fit);spi0.0:1m(uboot),5m(kernel),1m(dtb),9m(file_system)"
# CONFIG_SPL_EFI_PARTITION is not set
CONFIG_OF_CONTROL=y
CONFIG_ENV_OVERWRITE=y
CONFIG_ENV_IS_IN_MMC=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_USE_ETHPRIME=y
CONFIG_ETHPRIME="FM1@DTSEC3"
CONFIG_FSL_CAAM=y
CONFIG_MPC8XXX_GPIO=y
CONFIG_DM_I2C=y
CONFIG_SPL_SYS_I2C_LEGACY=y
CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
CONFIG_SYS_I2C_EEPROM_ADDR=0x53
CONFIG_FSL_ESDHC=y
CONFIG_MTD=y
CONFIG_MTD_NOR_FLASH=y
CONFIG_FLASH_CFI_DRIVER=y
CONFIG_CFI_FLASH_USE_WEAK_ACCESSORS=y
CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
CONFIG_SYS_FLASH_EMPTY_INFO=y
CONFIG_SYS_FLASH_CFI=y
CONFIG_SYS_FLASH_QUIET_TEST=y
CONFIG_SYS_MAX_FLASH_SECT=1024
CONFIG_MTD_RAW_NAND=y
CONFIG_NAND_FSL_IFC=y
CONFIG_SYS_NAND_ONFI_DETECTION=y
CONFIG_SF_DEFAULT_BUS=1
CONFIG_SPI_FLASH_EON=y
CONFIG_SPI_FLASH_STMICRO=y
CONFIG_SPI_FLASH_SST=y
CONFIG_PHYLIB=y
CONFIG_PHY_AQUANTIA=y
CONFIG_PHY_REALTEK=y
CONFIG_PHY_VITESSE=y
CONFIG_DM_MDIO=y
CONFIG_E1000=y
CONFIG_FMAN_ENET=y
CONFIG_SYS_FMAN_FW_ADDR=0x900000
CONFIG_NVME_PCI=y
CONFIG_PCIE_LAYERSCAPE_RC=y
CONFIG_SYS_QE_FW_ADDR=0x940000
CONFIG_SYS_QE_FMAN_FW_IN_MMC=y
CONFIG_DM_SERIAL=y
CONFIG_SPL_SYS_NS16550_SERIAL=y
CONFIG_SPI=y
CONFIG_DM_SPI=y
CONFIG_USB=y
CONFIG_USB_XHCI_HCD=y
CONFIG_USB_XHCI_DWC3=y
# CONFIG_SPL_USE_TINY_PRINTF is not set
CONFIG_EFI_LOADER_BOUNCE_BUFFER=y