CONFIG_PPC=y
CONFIG_SYS_TEXT_BASE=0x11001000
CONFIG_ENV_SIZE=0x4000
CONFIG_ENV_OFFSET=0x100000
CONFIG_SPL_TEXT_BASE=0xFF800000
CONFIG_SPL_SERIAL_SUPPORT=y
CONFIG_TPL_LIBCOMMON_SUPPORT=y
CONFIG_TPL_LIBGENERIC_SUPPORT=y
CONFIG_SPL_DRIVERS_MISC_SUPPORT=y
CONFIG_SPL=y
CONFIG_DEFAULT_DEVICE_TREE="p1010rdb-pa_36b"
CONFIG_MPC85xx=y
CONFIG_TARGET_P1010RDB_PA=y
CONFIG_PHYS_64BIT=y
CONFIG_SYS_CUSTOM_LDSCRIPT=y
CONFIG_SYS_LDSCRIPT="arch/powerpc/cpu/mpc85xx/u-boot-nand.lds"
CONFIG_FIT=y
CONFIG_FIT_VERBOSE=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_OF_STDOUT_VIA_ALIAS=y
CONFIG_BOOTDELAY=10
CONFIG_SYS_CONSOLE_IS_IN_ENV=y
CONFIG_BOARD_EARLY_INIT_F=y
CONFIG_BOARD_EARLY_INIT_R=y
# CONFIG_SPL_FRAMEWORK is not set
CONFIG_SPL_NAND_BOOT=y
CONFIG_SPL_NAND_SUPPORT=y
CONFIG_TPL=y
CONFIG_TPL_DRIVERS_MISC_SUPPORT=y
CONFIG_TPL_ENV_SUPPORT=y
CONFIG_TPL_I2C_SUPPORT=y
CONFIG_TPL_MPC8XXX_INIT_DDR_SUPPORT=y
CONFIG_TPL_NAND_SUPPORT=y
CONFIG_TPL_SERIAL_SUPPORT=y
CONFIG_HUSH_PARSER=y
CONFIG_CMD_IMLS=y
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
CONFIG_CMD_SF=y
CONFIG_CMD_USB=y
CONFIG_CMD_MII=y
CONFIG_CMD_PING=y
CONFIG_CMD_EXT2=y
CONFIG_CMD_FAT=y
CONFIG_MTDIDS_DEFAULT="nand0=ff800000.flash"
CONFIG_MTDPARTS_DEFAULT="mtdparts=ff800000.flash:2m(uboot-env),1m(dtb),5m(kernel),56m(fs),-(usr)"
CONFIG_OF_CONTROL=y
CONFIG_ENV_OVERWRITE=y
CONFIG_ENV_IS_IN_NAND=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_DM=y
CONFIG_FSL_CAAM=y
CONFIG_DM_I2C=y
CONFIG_FSL_ESDHC=y
CONFIG_MTD=y
CONFIG_MTD_NOR_FLASH=y
CONFIG_FLASH_CFI_DRIVER=y
CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
CONFIG_SYS_FLASH_CFI=y
CONFIG_MTD_RAW_NAND=y
CONFIG_SPI_FLASH=y
CONFIG_SF_DEFAULT_MODE=0
CONFIG_SF_DEFAULT_SPEED=10000000
CONFIG_SPI_FLASH_SPANSION=y
CONFIG_PHY_ATHEROS=y
CONFIG_PHY_BROADCOM=y
CONFIG_PHY_DAVICOM=y
CONFIG_PHY_LXT=y
CONFIG_PHY_MARVELL=y
CONFIG_PHY_NATSEMI=y
CONFIG_PHY_REALTEK=y
CONFIG_PHY_SMSC=y
CONFIG_PHY_VITESSE=y
CONFIG_PHY_GIGE=y
CONFIG_E1000=y
CONFIG_MII=y
CONFIG_TSEC_ENET=y
CONFIG_DM_PCI=y
CONFIG_DM_PCI_COMPAT=y
CONFIG_PCIE_FSL=y
CONFIG_DM_RTC=y
CONFIG_SYS_NS16550=y
CONFIG_SPI=y
CONFIG_FSL_ESPI=y
CONFIG_USB=y
CONFIG_USB_STORAGE=y
CONFIG_ADDR_MAP=y