board/freescale/mpc8548cds/mpc8548cds.c

// SPDX-License-Identifier: GPL-2.0+
/*
 * Copyright 2004, 2007, 2009-2011 Freescale Semiconductor, Inc.
 *
 * (C) Copyright 2002 Scott McNutt <smcnutt@artesyncp.com>
 */

#include <common.h>
#include <display_options.h>
#include <init.h>
#include <net.h>
#include <pci.h>
#include <vsprintf.h>
#include <asm/processor.h>
#include <asm/mmu.h>
#include <asm/immap_85xx.h>
#include <asm/fsl_pci.h>
#include <fsl_ddr_sdram.h>
#include <asm/fsl_serdes.h>
#include <miiphy.h>
#include <linux/delay.h>
#include <linux/libfdt.h>
#include <fdt_support.h>
#include <tsec.h>
#include <fsl_mdio.h>
#include <netdev.h>

#include "../common/cadmus.h"
#include "../common/eeprom.h"
#include "../common/via.h"

void local_bus_init(void);

int checkboard (void)
{
	volatile ccsr_gur_t *gur = (void *)(CFG_SYS_MPC85xx_GUTS_ADDR);
	volatile ccsr_local_ecm_t *ecm = (void *)(CFG_SYS_MPC85xx_ECM_ADDR);

	/* PCI slot in USER bits CSR[6:7] by convention. */
	uint pci_slot = get_pci_slot ();

	uint cpu_board_rev = get_cpu_board_revision ();

	puts("Board: MPC8548CDS");
	printf(" Carrier Rev: 0x%02x, PCI Slot %d\n",
			get_board_version(), pci_slot);
	printf("       Daughtercard Rev: %d.%d (0x%04x)\n",
		MPC85XX_CPU_BOARD_MAJOR (cpu_board_rev),
		MPC85XX_CPU_BOARD_MINOR (cpu_board_rev), cpu_board_rev);
	/*
	 * Initialize local bus.
	 */
	local_bus_init ();

	/*
	 * Hack TSEC 3 and 4 IO voltages.
	 */
	gur->tsec34ioovcr = 0xe7e0;	/*  1110 0111 1110 0xxx */

	ecm->eedr = 0xffffffff;		/* clear ecm errors */
	ecm->eeer = 0xffffffff;		/* enable ecm errors */
	return 0;
}

/*
 * Initialize Local Bus
 */
void
local_bus_init(void)
{
	volatile ccsr_gur_t *gur = (void *)(CFG_SYS_MPC85xx_GUTS_ADDR);
	volatile fsl_lbc_t *lbc = LBC_BASE_ADDR;

	uint clkdiv;
	sys_info_t sysinfo;

	get_sys_info(&sysinfo);
	clkdiv = (lbc->lcrr & LCRR_CLKDIV) * 2;

	gur->lbiuiplldcr1 = 0x00078080;
	if (clkdiv == 16) {
		gur->lbiuiplldcr0 = 0x7c0f1bf0;
	} else if (clkdiv == 8) {
		gur->lbiuiplldcr0 = 0x6c0f1bf0;
	} else if (clkdiv == 4) {
		gur->lbiuiplldcr0 = 0x5c0f1bf0;
	}

	lbc->lcrr |= 0x00030000;

	asm("sync;isync;msync");

	lbc->ltesr = 0xffffffff;	/* Clear LBC error interrupts */
	lbc->lteir = 0xffffffff;	/* Enable LBC error interrupts */
}

/*
 * Initialize SDRAM memory on the Local Bus.
 */
void lbc_sdram_init(void)
{
#if defined(CONFIG_SYS_OR2_PRELIM) && defined(CONFIG_SYS_BR2_PRELIM)

	uint idx;
	volatile fsl_lbc_t *lbc = LBC_BASE_ADDR;
	uint *sdram_addr = (uint *)CFG_SYS_LBC_SDRAM_BASE;
	uint lsdmr_common;

	puts("LBC SDRAM: ");
	print_size(CFG_SYS_LBC_SDRAM_SIZE * 1024 * 1024,
		   "\n");

	/*
	 * Setup SDRAM Base and Option Registers
	 */
	set_lbc_or(2, CONFIG_SYS_OR2_PRELIM);
	set_lbc_br(2, CONFIG_SYS_BR2_PRELIM);
	lbc->lbcr = CFG_SYS_LBC_LBCR;
	asm("msync");

	lbc->lsrt = CFG_SYS_LBC_LSRT;
	lbc->mrtpr = CFG_SYS_LBC_MRTPR;
	asm("msync");

	/*
	 * MPC8548 uses "new" 15-16 style addressing.
	 */
	lsdmr_common = CFG_SYS_LBC_LSDMR_COMMON;
	lsdmr_common |= LSDMR_BSMA1516;

	/*
	 * Issue PRECHARGE ALL command.
	 */
	lbc->lsdmr = lsdmr_common | LSDMR_OP_PCHALL;
	asm("sync;msync");
	*sdram_addr = 0xff;
	ppcDcbf((unsigned long) sdram_addr);
	udelay(100);

	/*
	 * Issue 8 AUTO REFRESH commands.
	 */
	for (idx = 0; idx < 8; idx++) {
		lbc->lsdmr = lsdmr_common | LSDMR_OP_ARFRSH;
		asm("sync;msync");
		*sdram_addr = 0xff;
		ppcDcbf((unsigned long) sdram_addr);
		udelay(100);
	}

	/*
	 * Issue 8 MODE-set command.
	 */
	lbc->lsdmr = lsdmr_common | LSDMR_OP_MRW;
	asm("sync;msync");
	*sdram_addr = 0xff;
	ppcDcbf((unsigned long) sdram_addr);
	udelay(100);

	/*
	 * Issue NORMAL OP command.
	 */
	lbc->lsdmr = lsdmr_common | LSDMR_OP_NORMAL;
	asm("sync;msync");
	*sdram_addr = 0xff;
	ppcDcbf((unsigned long) sdram_addr);
	udelay(200);    /* Overkill. Must wait > 200 bus cycles */

#endif	/* enable SDRAM init */
}

#ifndef CONFIG_DM_ETH
static void configure_rgmii(void)
{
	unsigned short temp;

	/* Change the resistors for the PHY */
	/* This is needed to get the RGMII working for the 1.3+
	 * CDS cards */
	if (get_board_version() ==  0x13) {
		miiphy_write(DEFAULT_MII_NAME,
				TSEC1_PHY_ADDR, 29, 18);

		miiphy_read(DEFAULT_MII_NAME,
				TSEC1_PHY_ADDR, 30, &temp);

		temp = (temp & 0xf03f);
		temp |= 2 << 9;		/* 36 ohm */
		temp |= 2 << 6;		/* 39 ohm */

		miiphy_write(DEFAULT_MII_NAME,
				TSEC1_PHY_ADDR, 30, temp);

		miiphy_write(DEFAULT_MII_NAME,
				TSEC1_PHY_ADDR, 29, 3);

		miiphy_write(DEFAULT_MII_NAME,
				TSEC1_PHY_ADDR, 30, 0x8000);
	}

	return;
}

int board_eth_init(struct bd_info *bis)
{
#ifdef CONFIG_TSEC_ENET
	struct fsl_pq_mdio_info mdio_info;
	struct tsec_info_struct tsec_info[4];
	int num = 0;

#ifdef CONFIG_TSEC1
	SET_STD_TSEC_INFO(tsec_info[num], 1);
	num++;
#endif
#ifdef CONFIG_TSEC2
	SET_STD_TSEC_INFO(tsec_info[num], 2);
	num++;
#endif
#ifdef CONFIG_TSEC3
	/* initialize TSEC3 only if Carrier is 1.3 or above on CDS */
	if (get_board_version() >= 0x13) {
		SET_STD_TSEC_INFO(tsec_info[num], 3);
		tsec_info[num].interface = PHY_INTERFACE_MODE_RGMII_ID;
		num++;
	}
#endif
#ifdef CONFIG_TSEC4
	/* initialize TSEC4 only if Carrier is 1.3 or above on CDS */
	if (get_board_version() >= 0x13) {
		SET_STD_TSEC_INFO(tsec_info[num], 4);
		tsec_info[num].interface = PHY_INTERFACE_MODE_RGMII_ID;
		num++;
	}
#endif

	if (!num) {
		printf("No TSECs initialized\n");

		return 0;
	}

	mdio_info.regs = (struct tsec_mii_mng *)CONFIG_SYS_MDIO_BASE_ADDR;
	mdio_info.name = DEFAULT_MII_NAME;
	fsl_pq_mdio_init(bis, &mdio_info);

	tsec_eth_init(bis, tsec_info, num);
	configure_rgmii();
#endif

	return pci_eth_init(bis);
}
#endif