blob: 21c5dce0978fa49caf50fb849f0e14ab292b3a86 [file] [log] [blame]
Tim Harvey88c307d2014-06-02 16:13:19 -07001/*
2 * Copyright (C) 2014 Gateworks Corporation
3 * Author: Tim Harvey <tharvey@gateworks.com>
4 *
5 * SPDX-License-Identifier: GPL-2.0+
6 */
7#ifndef __IMX6_SPL_CONFIG_H
8#define __IMX6_SPL_CONFIG_H
9
10#ifdef CONFIG_SPL
11
12#define CONFIG_SPL_FRAMEWORK
13
14/*
15 * see Figure 8-3 in IMX6DQ/IMX6SDL Reference manuals:
16 * - IMX6SDL OCRAM (IRAM) is from 0x00907000 to 0x0091FFFF
17 * - IMX6DQ has 2x IRAM of IMX6SDL but we intend to support IMX6SDL as well
18 * - BOOT ROM stack is at 0x0091FFB8
19 * - if icache/dcache is enabled (eFuse/strapping controlled) then the
20 * IMX BOOT ROM will setup MMU table at 0x00918000, therefore we need to
21 * fit between 0x00907000 and 0x00918000.
22 * - Additionally the BOOT ROM loads what they consider the firmware image
23 * which consists of a 4K header in front of us that contains the IVT, DCD
24 * and some padding thus 'our' max size is really 0x00908000 - 0x00918000
25 * or 64KB
26 */
Marek Vasut0351ef92014-08-04 01:47:11 +020027#define CONFIG_SYS_THUMB_BUILD
Tim Harvey88c307d2014-06-02 16:13:19 -070028#define CONFIG_SPL_LDSCRIPT "arch/arm/cpu/armv7/omap-common/u-boot-spl.lds"
29#define CONFIG_SPL_TEXT_BASE 0x00908000
Marek Vasutf91c09a2014-10-24 23:39:07 +020030#define CONFIG_SPL_MAX_SIZE 0x10000
Tim Harvey88c307d2014-06-02 16:13:19 -070031#define CONFIG_SPL_STACK 0x0091FFB8
32#define CONFIG_SPL_LIBCOMMON_SUPPORT
33#define CONFIG_SPL_LIBGENERIC_SUPPORT
34#define CONFIG_SPL_SERIAL_SUPPORT
35#define CONFIG_SPL_I2C_SUPPORT
36#define CONFIG_SPL_GPIO_SUPPORT
37
38/* NAND support */
39#if defined(CONFIG_SPL_NAND_SUPPORT)
40#define CONFIG_SPL_NAND_MXS
41#define CONFIG_SPL_DMA_SUPPORT
42#endif
43
44/* MMC support */
45#if defined(CONFIG_SPL_MMC_SUPPORT)
46#define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR 138 /* offset 69KB */
47#define CONFIG_SYS_U_BOOT_MAX_SIZE_SECTORS 800 /* 400 KB */
Paul Kocialkowskie2ccdf82014-11-08 23:14:55 +010048#define CONFIG_SYS_MMCSD_FS_BOOT_PARTITION 1
Tim Harvey88c307d2014-06-02 16:13:19 -070049#define CONFIG_SYS_MONITOR_LEN (CONFIG_SYS_U_BOOT_MAX_SIZE_SECTORS/2*1024)
50#endif
51
52/* SATA support */
53#if defined(CONFIG_SPL_SATA_SUPPORT)
54#define CONFIG_SPL_SATA_BOOT_DEVICE 0
55#define CONFIG_SYS_SATA_FAT_BOOT_PARTITION 1
56#endif
57
58/* Define the payload for FAT/EXT support */
59#if defined(CONFIG_SPL_FAT_SUPPORT) || defined(CONFIG_SPL_EXT_SUPPORT)
Guillaume GARDET205b4f32014-10-15 17:53:11 +020060#define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME "u-boot.img"
Tim Harvey88c307d2014-06-02 16:13:19 -070061#define CONFIG_SPL_LIBDISK_SUPPORT
62#endif
63
Peng Fanf9e89ff2014-12-30 17:24:02 +080064#if defined(CONFIG_MX6SX)
65#define CONFIG_SPL_BSS_START_ADDR 0x88200000
66#define CONFIG_SPL_BSS_MAX_SIZE 0x100000 /* 1 MB */
67#define CONFIG_SYS_SPL_MALLOC_START 0x88300000
68#define CONFIG_SYS_SPL_MALLOC_SIZE 0x3200000 /* 50 MB */
69#define CONFIG_SYS_TEXT_BASE 0x87800000
70#else
Tim Harvey88c307d2014-06-02 16:13:19 -070071#define CONFIG_SPL_BSS_START_ADDR 0x18200000
72#define CONFIG_SPL_BSS_MAX_SIZE 0x100000 /* 1 MB */
73#define CONFIG_SYS_SPL_MALLOC_START 0x18300000
74#define CONFIG_SYS_SPL_MALLOC_SIZE 0x3200000 /* 50 MB */
75#define CONFIG_SYS_TEXT_BASE 0x17800000
76#endif
Peng Fanf9e89ff2014-12-30 17:24:02 +080077#endif
Tim Harvey88c307d2014-06-02 16:13:19 -070078
79#endif