sm8x50-userdebug: Add a generic build target for Snapdragon 8 gen devboards
Supported only on Linux kernel v6.8 onwards, this is a
common configuration (64-bit only) target for Snapdragon 8
gen devboards.
Smoke tested on sm8550-hdk, sm8550-qrd and sm8650-qrd with
software rendering.
And since qcom,board-id and qcom,msm-id DT properties are no
longer accepted upstream, we used fdtoverlay to apply them
at build time. So make sure that the base DT is built with
`DTC_FLAGS=-@` build flag to allow overlays, otherwise
fdtoverlay command will run into "FDT_ERR_NOTFOUND" error at
the build time.
Signed-off-by: Amit Pundir <amit.pundir@linaro.org>
Change-Id: I2c6a0331173ef11a542b07ee3a270ece36d96786
diff --git a/sm8x50/device.mk b/sm8x50/device.mk
new file mode 100644
index 0000000..18ff4cf
--- /dev/null
+++ b/sm8x50/device.mk
@@ -0,0 +1,74 @@
+#
+# Copyright (C) 2024 The Android Open-Source Project
+#
+# Licensed under the Apache License, Version 2.0 (the "License");
+# you may not use this file except in compliance with the License.
+# You may obtain a copy of the License at
+#
+# http://www.apache.org/licenses/LICENSE-2.0
+#
+# Unless required by applicable law or agreed to in writing, software
+# distributed under the License is distributed on an "AS IS" BASIS,
+# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+# See the License for the specific language governing permissions and
+# limitations under the License.
+#
+
+# setup dalvik vm configs
+$(call inherit-product, frameworks/native/build/tablet-10in-xhdpi-2048-dalvik-heap.mk)
+
+include $(LOCAL_PATH)/../vendor-package-ver.mk
+$(call inherit-product, $(SRC_TARGET_DIR)/product/virtual_ab_ota.mk)
+
+# dlkm_loader
+include device/linaro/dragonboard/shared/utils/dlkm_loader/device.mk
+PRODUCT_COPY_FILES += \
+ device/linaro/dragonboard/shared/utils/dlkm_loader/dlkm_loader.rc:$(TARGET_COPY_OUT_VENDOR)/etc/init/dlkm_loader.rc
+
+# Build generic Audio HAL
+PRODUCT_PACKAGES += audio.primary.sm8x50
+
+# BootControl HAL
+PRODUCT_PACKAGES += \
+ android.hardware.boot@1.2-impl \
+ android.hardware.boot@1.2-impl.recovery \
+ android.hardware.boot@1.2-service
+
+# Set BT address
+PRODUCT_PACKAGES += bdaddr
+
+# Install bdaddr script
+PRODUCT_COPY_FILES += \
+ device/linaro/dragonboard/shared/utils/bdaddr/set_bdaddr.sh:$(TARGET_COPY_OUT_VENDOR)/bin/set_bdaddr.sh
+
+# Install scripts to set vendor.* properties
+PRODUCT_COPY_FILES += \
+ device/linaro/dragonboard/shared/utils/set_hw.sh:$(TARGET_COPY_OUT_VENDOR)/bin/set_hw.sh \
+ device/linaro/dragonboard/shared/utils/set_udc.sh:$(TARGET_COPY_OUT_VENDOR)/bin/set_udc.sh
+
+# Install scripts to set Ethernet MAC address
+PRODUCT_COPY_FILES += \
+ device/linaro/dragonboard/shared/utils/ethaddr/ethaddr.rc:$(TARGET_COPY_OUT_VENDOR)/etc/init/ethaddr.rc \
+ device/linaro/dragonboard/shared/utils/ethaddr/set_ethaddr.sh:$(TARGET_COPY_OUT_VENDOR)/bin/set_ethaddr.sh
+
+PRODUCT_COPY_FILES += \
+ $(LOCAL_PATH)/fstab:$(TARGET_COPY_OUT_RAMDISK)/first_stage_ramdisk/fstab.sm8x50 \
+ $(LOCAL_PATH)/fstab:$(TARGET_COPY_OUT_VENDOR)/etc/fstab.sm8x50
+
+PRODUCT_VENDOR_PROPERTIES += \
+ ro.soc.manufacturer=Snapdragon 8 Gen Devboard \
+ ro.soc.model=SM8x50
+
+PRODUCT_VENDOR_PROPERTIES += \
+ vendor.minigbm.debug=nocompression
+
+PRODUCT_SOONG_NAMESPACES += \
+ vendor/linaro/sm8x50/$(EXPECTED_LINARO_VENDOR_VERSION)
+
+# Copy firmware files
+$(call inherit-product-if-exists, vendor/linaro/sm8x50/$(EXPECTED_LINARO_VENDOR_VERSION)/device.mk)
+
+TARGET_HARDWARE := sm8x50
+TARGET_KERNEL_USE ?= mainline
+
+include device/linaro/dragonboard/device-common.mk