x86: Move ECC initialisation outside RAM initialisation
To allow for 'load anywhere' images, the %ebp return pointer 'hack' must
be removed, so we cannot have two 'calls' to get_mem_size
diff --git a/arch/i386/cpu/sc520/sc520_asm.S b/arch/i386/cpu/sc520/sc520_asm.S
index 7c2de31..e0d3102 100644
--- a/arch/i386/cpu/sc520/sc520_asm.S
+++ b/arch/i386/cpu/sc520/sc520_asm.S
@@ -517,22 +517,11 @@
jmp bad_reint
dram_done:
+ jmp *%ebp
#if CONFIG_SYS_SDRAM_ECC_ENABLE
- /*
- * We are in the middle of an existing 'call' - Need to store the
- * existing return address before making another 'call'
- */
- movl %ebp, %ebx
-
- /* Get the memory size */
- movl $init_ecc, %ebp
- jmpl get_mem_size
-
+.globl init_ecc
init_ecc:
- /* Restore the orignal return address */
- movl %ebx, %ebp
-
/* A nominal memory test: just a byte at each address line */
movl %eax, %ecx
shrl $0x1, %ecx
@@ -571,10 +560,10 @@
movl $ECCCTL, %edi
movb $0x05, %al
movb %al,(%edi)
-#endif
out:
jmp *%ebp
+#endif
/*
* Read and decode the sc520 DRCBENDADR MMCR and return the number of
diff --git a/arch/i386/cpu/start.S b/arch/i386/cpu/start.S
index cb47ce7..819274f 100644
--- a/arch/i386/cpu/start.S
+++ b/arch/i386/cpu/start.S
@@ -93,6 +93,17 @@
jmp get_mem_size
get_mem_size_ret:
+#if CONFIG_SYS_SDRAM_ECC_ENABLE
+ /* Skip ECC initialization if not starting from cold-reset */
+ movl %ebx, %ecx
+ andl $GD_FLG_COLD_BOOT, %ecx
+ jz init_ecc_ret
+ mov $init_ecc_ret, %ebp
+ jmp init_ecc
+
+init_ecc_ret:
+#endif
+
/* Check we have enough memory for stack */
movl $CONFIG_SYS_STACK_SIZE, %ecx
cmpl %ecx, %eax