twl4030: make twl4030_i2c_write_u8 prototype consistent
u-boot standard i2c register write prototype is
i2c_reg_write(u8 addr, u8 reg, u8 val)
twl4030_i2c_write_u8(u8 addr, u8 val, u8 reg)
does not provide consistency, so switch the prototype to be
consistent with rest of u-boot i2c operations:
twl4030_i2c_write_u8(u8 addr, u8 reg, u8 val)
Signed-off-by: Nishanth Menon <nm@ti.com>
diff --git a/drivers/power/twl4030.c b/drivers/power/twl4030.c
index e7d5f13..2bf94b1 100644
--- a/drivers/power/twl4030.c
+++ b/drivers/power/twl4030.c
@@ -51,8 +51,8 @@
printf("Could not initialize hardware reset\n");
} else {
val |= TWL4030_PM_MASTER_SW_EVENTS_STOPON_PWRON;
- if (twl4030_i2c_write_u8(TWL4030_CHIP_PM_MASTER, val,
- TWL4030_PM_MASTER_P1_SW_EVENTS)) {
+ if (twl4030_i2c_write_u8(TWL4030_CHIP_PM_MASTER,
+ TWL4030_PM_MASTER_P1_SW_EVENTS, val)) {
printf("Error:TWL4030: failed to write the power register\n");
printf("Could not initialize hardware reset\n");
}
@@ -68,8 +68,8 @@
int ret;
/* Select the Voltage */
- ret = twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER, vsel_val,
- vsel_reg);
+ ret = twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER, vsel_reg,
+ vsel_val);
if (ret != 0) {
printf("Could not write vsel to reg %02x (%d)\n",
vsel_reg, ret);
@@ -77,8 +77,8 @@
}
/* Select the Device Group (enable the supply if dev_grp_sel != 0) */
- ret = twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER, dev_grp_sel,
- dev_grp);
+ ret = twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER, dev_grp,
+ dev_grp_sel);
if (ret != 0)
printf("Could not write grp_sel to reg %02x (%d)\n",
dev_grp, ret);