twl4030: make twl4030_i2c_write_u8 prototype consistent
u-boot standard i2c register write prototype is
i2c_reg_write(u8 addr, u8 reg, u8 val)
twl4030_i2c_write_u8(u8 addr, u8 val, u8 reg)
does not provide consistency, so switch the prototype to be
consistent with rest of u-boot i2c operations:
twl4030_i2c_write_u8(u8 addr, u8 reg, u8 val)
Signed-off-by: Nishanth Menon <nm@ti.com>
diff --git a/drivers/usb/phy/twl4030.c b/drivers/usb/phy/twl4030.c
index 54d2e61..f41cc07 100644
--- a/drivers/usb/phy/twl4030.c
+++ b/drivers/usb/phy/twl4030.c
@@ -54,7 +54,7 @@
{
int ret;
- ret = twl4030_i2c_write_u8(TWL4030_CHIP_USB, data, address);
+ ret = twl4030_i2c_write_u8(TWL4030_CHIP_USB, address, data);
if (ret != 0)
printf("TWL4030:USB:Write[0x%x] Error %d\n", address, ret);
@@ -78,40 +78,40 @@
static void twl4030_usb_ldo_init(void)
{
/* Enable writing to power configuration registers */
- twl4030_i2c_write_u8(TWL4030_CHIP_PM_MASTER, 0xC0,
- TWL4030_PM_MASTER_PROTECT_KEY);
- twl4030_i2c_write_u8(TWL4030_CHIP_PM_MASTER, 0x0C,
- TWL4030_PM_MASTER_PROTECT_KEY);
+ twl4030_i2c_write_u8(TWL4030_CHIP_PM_MASTER,
+ TWL4030_PM_MASTER_PROTECT_KEY, 0xC0);
+ twl4030_i2c_write_u8(TWL4030_CHIP_PM_MASTER,
+ TWL4030_PM_MASTER_PROTECT_KEY, 0x0C);
/* put VUSB3V1 LDO in active state */
- twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER, 0x00,
- TWL4030_PM_RECEIVER_VUSB_DEDICATED2);
+ twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER,
+ TWL4030_PM_RECEIVER_VUSB_DEDICATED2, 0x00);
/* input to VUSB3V1 LDO is from VBAT, not VBUS */
- twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER, 0x14,
- TWL4030_PM_RECEIVER_VUSB_DEDICATED1);
+ twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER,
+ TWL4030_PM_RECEIVER_VUSB_DEDICATED1, 0x14);
/* turn on 3.1V regulator */
- twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER, 0x20,
- TWL4030_PM_RECEIVER_VUSB3V1_DEV_GRP);
- twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER, 0x00,
- TWL4030_PM_RECEIVER_VUSB3V1_TYPE);
+ twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER,
+ TWL4030_PM_RECEIVER_VUSB3V1_DEV_GRP, 0x20);
+ twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER,
+ TWL4030_PM_RECEIVER_VUSB3V1_TYPE, 0x00);
/* turn on 1.5V regulator */
- twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER, 0x20,
- TWL4030_PM_RECEIVER_VUSB1V5_DEV_GRP);
- twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER, 0x00,
- TWL4030_PM_RECEIVER_VUSB1V5_TYPE);
+ twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER,
+ TWL4030_PM_RECEIVER_VUSB1V5_DEV_GRP, 0x20);
+ twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER,
+ TWL4030_PM_RECEIVER_VUSB1V5_TYPE, 0x00);
/* turn on 1.8V regulator */
- twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER, 0x20,
- TWL4030_PM_RECEIVER_VUSB1V8_DEV_GRP);
- twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER, 0x00,
- TWL4030_PM_RECEIVER_VUSB1V8_TYPE);
+ twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER,
+ TWL4030_PM_RECEIVER_VUSB1V8_DEV_GRP, 0x20);
+ twl4030_i2c_write_u8(TWL4030_CHIP_PM_RECEIVER,
+ TWL4030_PM_RECEIVER_VUSB1V8_TYPE, 0x00);
/* disable access to power configuration registers */
- twl4030_i2c_write_u8(TWL4030_CHIP_PM_MASTER, 0x00,
- TWL4030_PM_MASTER_PROTECT_KEY);
+ twl4030_i2c_write_u8(TWL4030_CHIP_PM_MASTER,
+ TWL4030_PM_MASTER_PROTECT_KEY, 0x00);
}
static void twl4030_phy_power(void)