ppc4xx: Small whitespace fix of esd patches

Signed-off-by: Stefan Roese <sr@denx.de>
diff --git a/board/esd/pmc440/cmd_pmc440.c b/board/esd/pmc440/cmd_pmc440.c
index e9e9746..90d9309 100644
--- a/board/esd/pmc440/cmd_pmc440.c
+++ b/board/esd/pmc440/cmd_pmc440.c
@@ -503,15 +503,15 @@
 
 		/* map PCI address at 0xc0000000 in PLB space */
 
-                /* PMM1 Mask/Attribute - disabled b4 setting */
+		/* PMM1 Mask/Attribute - disabled b4 setting */
 		out32r(PCIX0_PMM1MA, 0x00000000);
-                /* PMM1 Local Address */
+		/* PMM1 Local Address */
 		out32r(PCIX0_PMM1LA, 0xc0000000);
-                /* PMM1 PCI Low Address */
+		/* PMM1 PCI Low Address */
 		out32r(PCIX0_PMM1PCILA, pciaddr);
-                /* PMM1 PCI High Address */
+		/* PMM1 PCI High Address */
 		out32r(PCIX0_PMM1PCIHA, 0x00000000);
-                /* 256MB + No prefetching, and enable region */
+		/* 256MB + No prefetching, and enable region */
 		out32r(PCIX0_PMM1MA, 0xf0000001);
 	} else {
 		printf("Usage:\npmm %s\n", cmdtp->help);
diff --git a/board/esd/pmc440/pmc440.c b/board/esd/pmc440/pmc440.c
index 7fadc42..5b811bb 100644
--- a/board/esd/pmc440/pmc440.c
+++ b/board/esd/pmc440/pmc440.c
@@ -565,7 +565,7 @@
 	pci_write_config_word(0, PCI_SUBSYSTEM_VENDOR_ID,
 			      CFG_PCI_SUBSYS_VENDORID);
 
-        /* disabled for PMC405 backward compatibility */
+	/* disabled for PMC405 backward compatibility */
 	/* Configure command register as bus master */
 	/* pci_write_config_word(0, PCI_COMMAND, PCI_COMMAND_MASTER); */
 
diff --git a/include/configs/DU440.h b/include/configs/DU440.h
index f193a43..d54da97 100644
--- a/include/configs/DU440.h
+++ b/include/configs/DU440.h
@@ -158,7 +158,7 @@
 #define CFG_MBYTES_SDRAM        (1024)	/* 512 MiB      TODO: remove    */
 #define CONFIG_DDR_DATA_EYE		/* use DDR2 optimization        */
 #define CFG_MEM_TOP_HIDE        (4 << 10) /* don't use last 4kbytes     */
-                                        /* 440EPx errata CHIP 11        */
+					/* 440EPx errata CHIP 11        */
 #define CONFIG_SPD_EEPROM		/* Use SPD EEPROM for setup     */
 #define CONFIG_DDR_ECC			/* Use ECC when available       */
 #define SPD_EEPROM_ADDRESS	{0x50}