Stop using immap_t on 85xx
In the future the offsets to various blocks may not be in same location.
Move to using CFG_MPC85xx_*_ADDR as the base of the registers
instead of getting it via &immap.
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/board/sbc8560/sbc8560.c b/board/sbc8560/sbc8560.c
index e02fb55..47df884 100644
--- a/board/sbc8560/sbc8560.c
+++ b/board/sbc8560/sbc8560.c
@@ -195,8 +195,7 @@
int board_early_init_f (void)
{
#if defined(CONFIG_PCI)
- volatile immap_t *immr = (immap_t *)CFG_IMMR;
- volatile ccsr_pcix_t *pci = &immr->im_pcix;
+ volatile ccsr_pcix_t *pci = (void *)(CFG_MPC85xx_PCIX_ADDR);
pci->peer &= 0xfffffffdf; /* disable master abort */
#endif
@@ -266,7 +265,7 @@
extern long spd_sdram (void);
#if 0
#if !defined(CONFIG_RAM_AS_FLASH)
- volatile ccsr_lbc_t *lbc= &immap->im_lbc;
+ volatile ccsr_lbc_t *lbc = (void *)(CFG_MPC85xx_LBC_ADDR);
sys_info_t sysinfo;
uint temp_lbcdll = 0;
#endif
@@ -335,8 +334,7 @@
* enable errors */
uint *p = 0;
uint i = 0;
- volatile immap_t *immap = (immap_t *)CFG_IMMR;
- volatile ccsr_ddr_t *ddr= &immap->im_ddr;
+ volatile ccsr_ddr_t *ddr= (void *)(CFG_MPC85xx_DDR_ADDR);
dma_init();
for (*p = 0; p < (uint *)(8 * 1024); p++) {
if (((unsigned int)p & 0x1f) == 0) { dcbz(p); }
@@ -423,8 +421,7 @@
#define CFG_DDR_CONTROL 0xc2000000
#ifndef CFG_RAMBOOT
- volatile immap_t *immap = (immap_t *)CFG_IMMR;
- volatile ccsr_ddr_t *ddr= &immap->im_ddr;
+ volatile ccsr_ddr_t *ddr= (void *)(CFG_MPC85xx_DDR_ADDR);
ddr->cs0_bnds = 0x00000007;
ddr->cs1_bnds = 0x0010001f;