nitrogen6x: display: add support for fusion 7 display
Add support for the Touch Revolution Fusion7 display: 800x480 RGB
with a custom F0710A resistive touch controller.
Auto-detection of this panel is supported so no configuration is
required.
Signed-off-by: Eric Nelson <eric.nelson@boundarydevices.com>
diff --git a/board/boundary/nitrogen6x/nitrogen6x.c b/board/boundary/nitrogen6x/nitrogen6x.c
index 045f81e..be2a41f 100644
--- a/board/boundary/nitrogen6x/nitrogen6x.c
+++ b/board/boundary/nitrogen6x/nitrogen6x.c
@@ -615,6 +615,26 @@
.vmode = FB_VMODE_NONINTERLACED
} }, {
.bus = 2,
+ .addr = 0x10,
+ .pixfmt = IPU_PIX_FMT_RGB666,
+ .detect = detect_i2c,
+ .enable = enable_rgb,
+ .mode = {
+ .name = "fusion7",
+ .refresh = 60,
+ .xres = 800,
+ .yres = 480,
+ .pixclock = 33898,
+ .left_margin = 96,
+ .right_margin = 24,
+ .upper_margin = 3,
+ .lower_margin = 10,
+ .hsync_len = 72,
+ .vsync_len = 7,
+ .sync = 0x40000002,
+ .vmode = FB_VMODE_NONINTERLACED
+} }, {
+ .bus = 2,
.addr = 0x48,
.pixfmt = IPU_PIX_FMT_RGB666,
.detect = detect_i2c,