driver/net/fec: support fixed speed connection
If MAC is directly connected to another MAC (like a switch for example)
we don't need to probe for a phy, autoneogation and so on. We simply
have to setup speed.
Signed-off-by: Hannes Schmelzer <oe5hpm@oevsv.at>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
diff --git a/doc/README.fec_mxc b/doc/README.fec_mxc
index ed7e47d..9ca6ac2 100644
--- a/doc/README.fec_mxc
+++ b/doc/README.fec_mxc
@@ -27,6 +27,11 @@
Optional, selects the exact phy address that should be connected
and function fecmxc_initialize will try to initialize it.
+CONFIG_FEC_FIXED_SPEED
+ Optional, selects a fixed speed on the MAC interface without asking some
+ phy. This is usefull if there is a direct MAC <-> MAC connection, for
+ example if the CPU is connected directly via the RGMII interface to a
+ ethernet-switch.
Reading the ethaddr from the SoC eFuses:
if CONFIG_FEC_MXC is defined and the U-Boot environment does not contain the
diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c
index 360f8e4..e871b3e 100644
--- a/drivers/net/fec_mxc.c
+++ b/drivers/net/fec_mxc.c
@@ -233,6 +233,7 @@
return ret;
}
+#ifndef CONFIG_FEC_FIXED_SPEED
static int miiphy_wait_aneg(struct eth_device *dev)
{
uint32_t start;
@@ -260,6 +261,7 @@
return 0;
}
+#endif /* CONFIG_FEC_FIXED_SPEED */
#endif
static int fec_rx_task_enable(struct fec_priv *fec)
@@ -502,6 +504,8 @@
}
speed = fec->phydev->speed;
}
+#elif CONFIG_FEC_FIXED_SPEED
+ speed = CONFIG_FEC_FIXED_SPEED;
#else
miiphy_wait_aneg(edev);
speed = miiphy_speed(edev->name, fec->phy_id);