| /* |
| * Internal Definitions |
| */ |
| #include <linux/stringify.h> |
| #define BOOTFLASH_START 0xF0000000 |
| |
| /* |
| * DDR Setup |
| */ |
| #define CFG_SYS_SDRAM_BASE 0x00000000 /* DDR is system memory */ |
| |
| #define CFG_SYS_DDR_SDRAM_CLK_CNTL (DDR_SDRAM_CLK_CNTL_SS_EN | \ |
| DDR_SDRAM_CLK_CNTL_CLK_ADJUST_05) |
| |
| #define CFG_83XX_DDR_USES_CS0 |
| |
| /* |
| * Manually set up DDR parameters |
| */ |
| #define CFG_SYS_SDRAM_SIZE 0x80000000 /* 2048 MiB */ |
| |
| /* |
| * The reserved memory |
| */ |
| #define CFG_SYS_FLASH_BASE 0xF0000000 |
| |
| /* Reserve 768 kB for Mon */ |
| |
| /* |
| * Initial RAM Base Address Setup |
| */ |
| #define CFG_SYS_INIT_RAM_ADDR 0xE6000000 /* Initial RAM address */ |
| #define CFG_SYS_INIT_RAM_SIZE 0x1000 /* End of used area in RAM */ |
| /* |
| * Init Local Bus Memory Controller: |
| * |
| * Bank Bus Machine PortSz Size Device |
| * ---- --- ------- ------ ----- ------ |
| * 0 Local GPCM 16 bit 256MB FLASH |
| * 1 Local GPCM 8 bit 128MB GPIO/PIGGY |
| * |
| */ |
| |
| /* |
| * FLASH on the Local Bus |
| */ |
| #define CFG_SYS_FLASH_SIZE 256 /* max FLASH size is 256M */ |
| |
| #define CFG_SYS_FLASH_BANKS_LIST { CFG_SYS_FLASH_BASE } |
| |
| #if defined(CONFIG_CMD_NAND) |
| #define CFG_SYS_NAND_BASE CFG_SYS_KMBEC_FPGA_BASE |
| #endif |
| |
| /* |
| * For booting Linux, the board info and command line data |
| * have to be in the first 8 MB of memory, since this is |
| * the maximum mapped by the Linux kernel during initialization. |
| */ |
| #define CFG_SYS_BOOTMAPSZ (8 << 20) |
| |
| /* |
| * QE UEC ethernet configuration |
| */ |
| #define CONFIG_UEC_ETH |