usb: ci_udc: make PHY initialization conditional

usb_gadget_register_driver() currently unconditionally programs PORTSC
to select a ULPI PHY. This is incorrect on at least the Tegra boards I
am testing with, which use a UTMI PHY for the OTG ports. Make the PHY
selection code conditional upon the specific EHCI controller that is in
use.

Ideally, I believe that the PHY initialization code should be part of
ehci_hcd_init() in the relevant EHCI controller driver, or some board-
specific function that ehci_hcd_init() calls.

For MX6, I'm not sure this PHY initialization code is correct even before
this patch, since ehci-mx6's ehci_hcd_init() already configures PORTSC to
a board-specific value, and it seems likely that the code in ci_udc.c is
incorrectly undoing this. Perhaps this is not an issue if the PHY
selection register bits aren't implemented on this instance of the MX6
USB controller?

ehci-mxs.c doens't appear to touch PORTSC, so this code is likely still
required there.

Signed-off-by: Stephen Warren <swarren@nvidia.com>
diff --git a/drivers/usb/gadget/ci_udc.c b/drivers/usb/gadget/ci_udc.c
index 832606f..fd751a2 100644
--- a/drivers/usb/gadget/ci_udc.c
+++ b/drivers/usb/gadget/ci_udc.c
@@ -702,7 +702,6 @@
 
 int usb_gadget_register_driver(struct usb_gadget_driver *driver)
 {
-	struct ci_udc *udc;
 	int ret;
 
 	if (!driver)
@@ -717,12 +716,18 @@
 		return ret;
 
 	ret = ci_udc_probe();
+#if defined(CONFIG_USB_EHCI_MX6) || defined(CONFIG_USB_EHCI_MXS)
+	/*
+	 * FIXME: usb_lowlevel_init()->ehci_hcd_init() should be doing all
+	 * HW-specific initialization, e.g. ULPI-vs-UTMI PHY selection
+	 */
 	if (!ret) {
-		udc = (struct ci_udc *)controller.ctrl->hcor;
+		struct ci_udc *udc = (struct ci_udc *)controller.ctrl->hcor;
 
 		/* select ULPI phy */
 		writel(PTS(PTS_ENABLE) | PFSC, &udc->portsc);
 	}
+#endif
 
 	ret = driver->bind(&controller.gadget);
 	if (ret) {