sf: always read 5 bytes for the idcode
Some SPI flash drivers like to have extended id information available
(like the spansion flash), so rather than making it re-issue the ID cmd
to get at the last 2 bytes, have the common code read 5 bytes rather than
just 3. This also matches the Linux behavior where it always reads 5 id
bytes from all flashes.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
Acked-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
CC: Mingkai Hu <Mingkai.hu@freescale.com>
diff --git a/drivers/mtd/spi/spi_flash.c b/drivers/mtd/spi/spi_flash.c
index 21ba5f9..274895a 100644
--- a/drivers/mtd/spi/spi_flash.c
+++ b/drivers/mtd/spi/spi_flash.c
@@ -101,7 +101,7 @@
struct spi_slave *spi;
struct spi_flash *flash;
int ret;
- u8 idcode[3];
+ u8 idcode[5];
spi = spi_setup_slave(bus, cs, max_hz, spi_mode);
if (!spi) {
@@ -120,8 +120,8 @@
if (ret)
goto err_read_id;
- debug("SF: Got idcode %02x %02x %02x\n", idcode[0],
- idcode[1], idcode[2]);
+ debug("SF: Got idcode %02x %02x %02x %02x %02x\n", idcode[0],
+ idcode[1], idcode[2], idcode[3], idcode[4]);
switch (idcode[0]) {
#ifdef CONFIG_SPI_FLASH_SPANSION