pinctrl: mxs: Add support for i.MX2[38] mxs pinctrl driver
The code responsible for setting proper values in the MUX registers
(in the mxs_pinctrl_set_state()) has been ported from Linux kernel
- SHA1: 17bb763e7eaf tag v5.1.11 from linux-stable.
As the pinctrl node in the imx28.dtsi file has gpio pins nodes as subnodes,
it was necessary to use 'dm_scan_fdt_dev()' (as a .bind method) to also
make them 'visible' by the DM's "gpio_mxs" driver.
Signed-off-by: Lukasz Majewski <lukma@denx.de>
Reviewed-by: Marek Vasut <marex@denx.de>
diff --git a/drivers/pinctrl/nxp/Kconfig b/drivers/pinctrl/nxp/Kconfig
index 61f93be..f2e67ca 100644
--- a/drivers/pinctrl/nxp/Kconfig
+++ b/drivers/pinctrl/nxp/Kconfig
@@ -89,6 +89,16 @@
only parses the 'fsl,pins' property and configure related
registers.
+config PINCTRL_MXS
+ bool "NXP MXS pinctrl driver"
+ depends on ARCH_MX28 && PINCTRL_FULL
+ help
+ Say Y here to enable the i.MX mxs pinctrl driver
+
+ This option provides a simple pinctrl driver for i.MX mxs SoC
+ familiy, e.g. i.MX28. This feature depends on device tree
+ configuration.
+
config PINCTRL_VYBRID
bool "Vybrid (vf610) pinctrl driver"
depends on ARCH_VF610 && PINCTRL_FULL
diff --git a/drivers/pinctrl/nxp/Makefile b/drivers/pinctrl/nxp/Makefile
index b340d94..b86448a 100644
--- a/drivers/pinctrl/nxp/Makefile
+++ b/drivers/pinctrl/nxp/Makefile
@@ -6,4 +6,5 @@
obj-$(CONFIG_PINCTRL_IMX_SCU) += pinctrl-scu.o
obj-$(CONFIG_PINCTRL_IMX8) += pinctrl-imx8.o
obj-$(CONFIG_PINCTRL_IMX8M) += pinctrl-imx8m.o
+obj-$(CONFIG_PINCTRL_MXS) += pinctrl-mxs.o
obj-$(CONFIG_PINCTRL_VYBRID) += pinctrl-vf610.o
diff --git a/drivers/pinctrl/nxp/pinctrl-mxs.c b/drivers/pinctrl/nxp/pinctrl-mxs.c
new file mode 100644
index 0000000..6f6ca84
--- /dev/null
+++ b/drivers/pinctrl/nxp/pinctrl-mxs.c
@@ -0,0 +1,190 @@
+// SPDX-License-Identifier: GPL-2.0+
+/*
+ * Copyright (C) 2019 DENX Software Engineering
+ * Lukasz Majewski, DENX Software Engineering, lukma@denx.de
+ */
+
+#include <common.h>
+#include <linux/io.h>
+#include <linux/err.h>
+#include <dm.h>
+#include <dm/pinctrl.h>
+#include <dm/read.h>
+#include "pinctrl-mxs.h"
+
+DECLARE_GLOBAL_DATA_PTR;
+
+struct mxs_pinctrl_priv {
+ void __iomem *base;
+ const struct mxs_regs *regs;
+};
+
+static unsigned long mxs_dt_node_to_map(struct udevice *conf)
+{
+ unsigned long config = 0;
+ int ret;
+ u32 val;
+
+ ret = dev_read_u32(conf, "fsl,drive-strength", &val);
+ if (!ret)
+ config = val | MA_PRESENT;
+
+ ret = dev_read_u32(conf, "fsl,voltage", &val);
+ if (!ret)
+ config |= val << VOL_SHIFT | VOL_PRESENT;
+
+ ret = dev_read_u32(conf, "fsl,pull-up", &val);
+ if (!ret)
+ config |= val << PULL_SHIFT | PULL_PRESENT;
+
+ return config;
+}
+
+static int mxs_pinctrl_set_mux(struct udevice *dev, u32 val, int bank, int pin)
+{
+ struct mxs_pinctrl_priv *iomux = dev_get_priv(dev);
+ int muxsel = MUXID_TO_MUXSEL(val), shift;
+ void __iomem *reg;
+
+ reg = iomux->base + iomux->regs->muxsel;
+ reg += bank * 0x20 + pin / 16 * 0x10;
+ shift = pin % 16 * 2;
+
+ mxs_pinctrl_rmwl(muxsel, 0x3, shift, reg);
+ debug(" mux %d,", muxsel);
+
+ return 0;
+}
+
+static int mxs_pinctrl_set_state(struct udevice *dev, struct udevice *conf)
+{
+ struct mxs_pinctrl_priv *iomux = dev_get_priv(dev);
+ u32 *pin_data, val, ma, vol, pull;
+ int npins, size, i, ret;
+ unsigned long config;
+
+ debug("\n%s: set state: %s\n", __func__, conf->name);
+
+ size = dev_read_size(conf, "fsl,pinmux-ids");
+ if (size < 0)
+ return size;
+
+ if (!size || size % sizeof(int)) {
+ dev_err(dev, "Invalid fsl,pinmux-ids property in %s\n",
+ conf->name);
+ return -EINVAL;
+ }
+
+ npins = size / sizeof(int);
+
+ pin_data = devm_kzalloc(dev, size, 0);
+ if (!pin_data)
+ return -ENOMEM;
+
+ ret = dev_read_u32_array(conf, "fsl,pinmux-ids", pin_data, npins);
+ if (ret) {
+ dev_err(dev, "Error reading pin data.\n");
+ devm_kfree(dev, pin_data);
+ return -EINVAL;
+ }
+
+ config = mxs_dt_node_to_map(conf);
+
+ ma = CONFIG_TO_MA(config);
+ vol = CONFIG_TO_VOL(config);
+ pull = CONFIG_TO_PULL(config);
+
+ for (i = 0; i < npins; i++) {
+ int pinid, bank, pin, shift;
+ void __iomem *reg;
+
+ val = pin_data[i];
+
+ pinid = MUXID_TO_PINID(val);
+ bank = PINID_TO_BANK(pinid);
+ pin = PINID_TO_PIN(pinid);
+
+ debug("(val: 0x%x) pin %d,", val, pinid);
+ /* Setup pinmux */
+ mxs_pinctrl_set_mux(dev, val, bank, pin);
+
+ debug(" ma: %d, vol: %d, pull: %d\n", ma, vol, pull);
+
+ /* drive */
+ reg = iomux->base + iomux->regs->drive;
+ reg += bank * 0x40 + pin / 8 * 0x10;
+
+ /* mA */
+ if (config & MA_PRESENT) {
+ shift = pin % 8 * 4;
+ mxs_pinctrl_rmwl(ma, 0x3, shift, reg);
+ }
+
+ /* vol */
+ if (config & VOL_PRESENT) {
+ shift = pin % 8 * 4 + 2;
+ if (vol)
+ writel(1 << shift, reg + SET);
+ else
+ writel(1 << shift, reg + CLR);
+ }
+
+ /* pull */
+ if (config & PULL_PRESENT) {
+ reg = iomux->base + iomux->regs->pull;
+ reg += bank * 0x10;
+ shift = pin;
+ if (pull)
+ writel(1 << shift, reg + SET);
+ else
+ writel(1 << shift, reg + CLR);
+ }
+ }
+
+ devm_kfree(dev, pin_data);
+ return 0;
+}
+
+static struct pinctrl_ops mxs_pinctrl_ops = {
+ .set_state = mxs_pinctrl_set_state,
+};
+
+static int mxs_pinctrl_probe(struct udevice *dev)
+{
+ struct mxs_pinctrl_priv *iomux = dev_get_priv(dev);
+
+ iomux->base = dev_read_addr_ptr(dev);
+ iomux->regs = (struct mxs_regs *)dev_get_driver_data(dev);
+
+ return 0;
+}
+
+static const struct mxs_regs imx23_regs = {
+ .muxsel = 0x100,
+ .drive = 0x200,
+ .pull = 0x400,
+};
+
+static const struct mxs_regs imx28_regs = {
+ .muxsel = 0x100,
+ .drive = 0x300,
+ .pull = 0x600,
+};
+
+static const struct udevice_id mxs_pinctrl_match[] = {
+ { .compatible = "fsl,imx23-pinctrl", .data = (ulong)&imx23_regs },
+ { .compatible = "fsl,imx28-pinctrl", .data = (ulong)&imx28_regs },
+ { /* sentinel */ }
+};
+
+U_BOOT_DRIVER(mxs_pinctrl) = {
+ .name = "mxs-pinctrl",
+ .id = UCLASS_PINCTRL,
+ .of_match = of_match_ptr(mxs_pinctrl_match),
+ .probe = mxs_pinctrl_probe,
+#if !CONFIG_IS_ENABLED(OF_PLATDATA)
+ .bind = dm_scan_fdt_dev,
+#endif
+ .priv_auto_alloc_size = sizeof(struct mxs_pinctrl_priv),
+ .ops = &mxs_pinctrl_ops,
+};
diff --git a/drivers/pinctrl/nxp/pinctrl-mxs.h b/drivers/pinctrl/nxp/pinctrl-mxs.h
new file mode 100644
index 0000000..a398e43
--- /dev/null
+++ b/drivers/pinctrl/nxp/pinctrl-mxs.h
@@ -0,0 +1,61 @@
+// SPDX-License-Identifier: GPL-2.0+
+/*
+ * Copyright 2012 Freescale Semiconductor, Inc.
+ */
+
+#ifndef __PINCTRL_MXS_H
+#define __PINCTRL_MXS_H
+
+#include <dm/pinctrl.h>
+
+#define SET 0x4
+#define CLR 0x8
+#define TOG 0xc
+
+#define MXS_PINCTRL_PIN(pin) PINCTRL_PIN(pin, #pin)
+#define PINID(bank, pin) ((bank) * 32 + (pin))
+
+/*
+ * pinmux-id bit field definitions
+ *
+ * bank: 15..12 (4)
+ * pin: 11..4 (8)
+ * muxsel: 3..0 (4)
+ */
+#define MUXID_TO_PINID(m) PINID((m) >> 12 & 0xf, (m) >> 4 & 0xff)
+#define MUXID_TO_MUXSEL(m) ((m) & 0xf)
+
+#define PINID_TO_BANK(p) ((p) >> 5)
+#define PINID_TO_PIN(p) ((p) % 32)
+
+/*
+ * pin config bit field definitions
+ *
+ * pull-up: 6..5 (2)
+ * voltage: 4..3 (2)
+ * mA: 2..0 (3)
+ *
+ * MSB of each field is presence bit for the config.
+ */
+#define PULL_PRESENT (1 << 6)
+#define PULL_SHIFT 5
+#define VOL_PRESENT (1 << 4)
+#define VOL_SHIFT 3
+#define MA_PRESENT (1 << 2)
+#define MA_SHIFT 0
+#define CONFIG_TO_PULL(c) ((c) >> PULL_SHIFT & 0x1)
+#define CONFIG_TO_VOL(c) ((c) >> VOL_SHIFT & 0x1)
+#define CONFIG_TO_MA(c) ((c) >> MA_SHIFT & 0x3)
+
+struct mxs_regs {
+ u16 muxsel;
+ u16 drive;
+ u16 pull;
+};
+
+static inline void mxs_pinctrl_rmwl(u32 value, u32 mask, u8 shift,
+ void __iomem *reg)
+{
+ clrsetbits_le32(reg, mask << shift, value << shift);
+}
+#endif /* __PINCTRL_MXS_H */