Correct SPL uses of USB_MUSB_HOST
This converts 2 usages of this option to the non-SPL form, since there is
no SPL_USB_MUSB_HOST defined in Kconfig
Signed-off-by: Simon Glass <sjg@chromium.org>
diff --git a/drivers/phy/phy-ab8500-usb.c b/drivers/phy/phy-ab8500-usb.c
index 0e04595..3d3d48c 100644
--- a/drivers/phy/phy-ab8500-usb.c
+++ b/drivers/phy/phy-ab8500-usb.c
@@ -19,7 +19,7 @@
struct udevice *dev = phy->dev;
uint set = AB8500_BIT_PHY_CTRL_DEVICE_EN;
- if (CONFIG_IS_ENABLED(USB_MUSB_HOST))
+ if (IS_ENABLED(CONFIG_USB_MUSB_HOST))
set = AB8500_BIT_PHY_CTRL_HOST_EN;
return pmic_clrsetbits(dev->parent, AB8500_USB_PHY_CTRL_REG,
diff --git a/drivers/usb/musb-new/omap2430.c b/drivers/usb/musb-new/omap2430.c
index 42e7abd..482dfdc 100644
--- a/drivers/usb/musb-new/omap2430.c
+++ b/drivers/usb/musb-new/omap2430.c
@@ -231,7 +231,7 @@
otg_board_data = &plat->otg_board_data;
- if (CONFIG_IS_ENABLED(USB_MUSB_HOST)) {
+ if (IS_ENABLED(CONFIG_USB_MUSB_HOST)) {
struct musb_host_data *host = dev_get_priv(dev);
struct usb_bus_priv *priv = dev_get_uclass_priv(dev);