mxs: Properly setup VDDD in power supply setup code
The memory setup code adjusted the VDDD voltage. Remove this adjustment
and configure the VDDD voltage correctly in the power supply setup code.
Signed-off-by: Marek Vasut <marex@denx.de>
Cc: Stefano Babic <sbabic@denx.de>
Cc: Fabio Estevam <fabio.estevam@freescale.com>
diff --git a/arch/arm/cpu/arm926ejs/mxs/spl_mem_init.c b/arch/arm/cpu/arm926ejs/mxs/spl_mem_init.c
index e693145..8904e24 100644
--- a/arch/arm/cpu/arm926ejs/mxs/spl_mem_init.c
+++ b/arch/arm/cpu/arm926ejs/mxs/spl_mem_init.c
@@ -171,17 +171,6 @@
&power_regs->hw_power_vddactrl);
}
-void mxs_mem_setup_vddd(void)
-{
- struct mxs_power_regs *power_regs =
- (struct mxs_power_regs *)MXS_POWER_BASE;
-
- writel((0x1c << POWER_VDDDCTRL_TRG_OFFSET) |
- (0x7 << POWER_VDDDCTRL_BO_OFFSET_OFFSET) |
- POWER_VDDDCTRL_LINREG_OFFSET_1STEPS_BELOW,
- &power_regs->hw_power_vdddctrl);
-}
-
uint32_t mxs_mem_get_size(void)
{
uint32_t sz, da;
@@ -241,8 +230,6 @@
while (!(readl(MXS_DRAM_BASE + 0xe8) & (1 << 20)))
;
- mxs_mem_setup_vddd();
-
early_delay(10000);
mxs_mem_setup_cpu_and_hbus();
diff --git a/arch/arm/cpu/arm926ejs/mxs/spl_power_init.c b/arch/arm/cpu/arm926ejs/mxs/spl_power_init.c
index 0d80158..2bc6ad1 100644
--- a/arch/arm/cpu/arm926ejs/mxs/spl_power_init.c
+++ b/arch/arm/cpu/arm926ejs/mxs/spl_power_init.c
@@ -897,7 +897,7 @@
mxs_enable_output_rail_protection();
mxs_power_set_vddx(&mxs_vddio_cfg, 3300, 3150);
- mxs_power_set_vddx(&mxs_vddd_cfg, 1350, 1200);
+ mxs_power_set_vddx(&mxs_vddd_cfg, 1500, 1000);
writel(POWER_CTRL_VDDD_BO_IRQ | POWER_CTRL_VDDA_BO_IRQ |
POWER_CTRL_VDDIO_BO_IRQ | POWER_CTRL_VDD5V_DROOP_IRQ |