arm64: zynqmp: Describe TI phy as ethernet-phy-id
TI DP83867 is using strapping based on MIO pins. Tristate setup can influce
PHY address. That's why switch description with ethernet-phy-id compatible
string which enable calling reset. PHY itself setups phy address after
power up or reset. Reset description will be added in separate commit.
Signed-off-by: Michal Simek <michal.simek@amd.com>
Link: https://lore.kernel.org/r/52bf9ac0453d4e4896d8edd2618e684bb1ff6012.1662721547.git.michal.simek@amd.com
diff --git a/arch/arm/dts/zynqmp-zcu216-revA.dts b/arch/arm/dts/zynqmp-zcu216-revA.dts
index caae169..80e7ddb 100644
--- a/arch/arm/dts/zynqmp-zcu216-revA.dts
+++ b/arch/arm/dts/zynqmp-zcu216-revA.dts
@@ -176,15 +176,20 @@
status = "okay";
phy-handle = <&phy0>;
phy-mode = "rgmii-id";
- phy0: ethernet-phy@c {
- reg = <0xc>;
- ti,rx-internal-delay = <0x8>;
- ti,tx-internal-delay = <0xa>;
- ti,fifo-depth = <0x1>;
- ti,dp83867-rxctrl-strap-quirk;
+ mdio: mdio {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ phy0: ethernet-phy@c {
+ #phy-cells = <1>;
+ compatible = "ethernet-phy-id2000.a231";
+ reg = <0xc>;
+ ti,rx-internal-delay = <0x8>;
+ ti,tx-internal-delay = <0xa>;
+ ti,fifo-depth = <0x1>;
+ ti,dp83867-rxctrl-strap-quirk;
+ };
};
};
-
&gpio {
status = "okay";
gpio-line-names = "QSPI_LWR_CLK", "QSPI_LWR_DQ1", "QSPI_LWR_DQ2", "QSPI_LWR_DQ3", "QSPI_LWR_DQ0", /* 0 - 4 */