mmc: sdhci: Enable 8-bit bus width only for 3.0 spec onwards
CAP register don't have any information for 8-bit buswidth support
on 2.0 sdhci spec, only from 3.0 onwards bit[18] got this information.
Due to this misassignment in sdhci, mmc is setting 8-bit buswidth using
mmc_set_bus_width even if controller doesn't support.
Below change has code information.
"mmc: Properly determine maximum supported bus width"
(sha1: 7798f6dbd5e1a3030ed81a81da5dfb57c3307cac)
Bug log: <mmc plus and emmc cards)
-------
zynq-uboot> mmcinfo
Error detected in status(0x208100)!
Device: zynq_sdhci
Manufacturer ID: fe
.....
So enable 8-bit support only for 3.0 spec using CAP and for below 3.0
assign mmc->host_caps = MMC_MODE_8BIT on respective platform driver
if host have a support.
Signed-off-by: Jagannadha Sutradharudu Teki <jaganna@xilinx.com>
Signed-off-by: Andy Fleming <afleming@freescale.com>
diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c
index 1eaea04..c5631bf 100644
--- a/drivers/mmc/sdhci.c
+++ b/drivers/mmc/sdhci.c
@@ -486,8 +486,10 @@
mmc->voltages |= host->voltages;
mmc->host_caps = MMC_MODE_HS | MMC_MODE_HS_52MHz | MMC_MODE_4BIT;
- if (caps & SDHCI_CAN_DO_8BIT)
- mmc->host_caps |= MMC_MODE_8BIT;
+ if ((host->version & SDHCI_SPEC_VER_MASK) >= SDHCI_SPEC_300) {
+ if (caps & SDHCI_CAN_DO_8BIT)
+ mmc->host_caps |= MMC_MODE_8BIT;
+ }
if (host->host_caps)
mmc->host_caps |= host->host_caps;