driver/ddr: Restruct driver to allow standalone memory space
U-boot has been initializing DDR for the main memory. The presumption
is the memory stays as a big continuous block, either linear or
interleaved. This change is to support putting some DDR controllers
to separated space without counting into main memory. The standalone
memory controller could use different number of DIMM slots.
Signed-off-by: York Sun <yorksun@freescale.com>
diff --git a/arch/powerpc/cpu/mpc85xx/cpu.c b/arch/powerpc/cpu/mpc85xx/cpu.c
index 6274f92..3d6ec84 100644
--- a/arch/powerpc/cpu/mpc85xx/cpu.c
+++ b/arch/powerpc/cpu/mpc85xx/cpu.c
@@ -441,7 +441,7 @@
/* Board-specific functions defined in each board's ddr.c */
void fsl_ddr_get_spd(generic_spd_eeprom_t *ctrl_dimms_spd,
- unsigned int ctrl_num);
+ unsigned int ctrl_num, unsigned int dimm_slots_per_ctrl);
void read_tlbcam_entry(int idx, u32 *valid, u32 *tsize, unsigned long *epn,
phys_addr_t *rpn);
unsigned int
@@ -459,7 +459,7 @@
spd[CONFIG_NUM_DDR_CONTROLLERS][CONFIG_DIMM_SLOTS_PER_CTLR];
for (i = 0; i < CONFIG_NUM_DDR_CONTROLLERS; i++)
- fsl_ddr_get_spd(spd[i], i);
+ fsl_ddr_get_spd(spd[i], i, CONFIG_DIMM_SLOTS_PER_CTLR);
puts("SPD data of all dimms (zero vaule is omitted)...\n");
puts("Byte (hex) ");