driver/ddr: Restruct driver to allow standalone memory space
U-boot has been initializing DDR for the main memory. The presumption
is the memory stays as a big continuous block, either linear or
interleaved. This change is to support putting some DDR controllers
to separated space without counting into main memory. The standalone
memory controller could use different number of DIMM slots.
Signed-off-by: York Sun <yorksun@freescale.com>
diff --git a/drivers/ddr/fsl/util.c b/drivers/ddr/fsl/util.c
index 7a22aa3..58b519b 100644
--- a/drivers/ddr/fsl/util.c
+++ b/drivers/ddr/fsl/util.c
@@ -149,7 +149,7 @@
return val;
}
-void board_add_ram_info(int use_default)
+void print_ddr_info(unsigned int start_ctrl)
{
struct ccsr_ddr __iomem *ddr =
(struct ccsr_ddr __iomem *)(CONFIG_SYS_FSL_DDR_ADDR);
@@ -164,17 +164,25 @@
int cas_lat;
#if CONFIG_NUM_DDR_CONTROLLERS >= 2
- if (!(sdram_cfg & SDRAM_CFG_MEM_EN)) {
+ if ((!(sdram_cfg & SDRAM_CFG_MEM_EN)) ||
+ (start_ctrl == 1)) {
ddr = (void __iomem *)CONFIG_SYS_FSL_DDR2_ADDR;
sdram_cfg = ddr_in32(&ddr->sdram_cfg);
}
#endif
#if CONFIG_NUM_DDR_CONTROLLERS >= 3
- if (!(sdram_cfg & SDRAM_CFG_MEM_EN)) {
+ if ((!(sdram_cfg & SDRAM_CFG_MEM_EN)) ||
+ (start_ctrl == 2)) {
ddr = (void __iomem *)CONFIG_SYS_FSL_DDR3_ADDR;
sdram_cfg = ddr_in32(&ddr->sdram_cfg);
}
#endif
+
+ if (!(sdram_cfg & SDRAM_CFG_MEM_EN)) {
+ puts(" (DDR not enabled)\n");
+ return;
+ }
+
puts(" (DDR");
switch ((sdram_cfg & SDRAM_CFG_SDRAM_TYPE_MASK) >>
SDRAM_CFG_SDRAM_TYPE_SHIFT) {
@@ -241,7 +249,7 @@
#endif
#endif
#if (CONFIG_NUM_DDR_CONTROLLERS >= 2)
- if (cs0_config & 0x20000000) {
+ if ((cs0_config & 0x20000000) && (start_ctrl == 0)) {
puts("\n");
puts(" DDR Controller Interleaving Mode: ");
@@ -290,3 +298,13 @@
}
}
}
+
+void __weak detail_board_ddr_info(void)
+{
+ print_ddr_info(0);
+}
+
+void board_add_ram_info(int use_default)
+{
+ detail_board_ddr_info();
+}