board: ge: bx50v3, imx53ppd: use DM I2C
Remove old (pre-DM) i2c setup code.
Enable DM i2c.
Convert common code to use DM rtc.
Convert common code to read VPD from eeprom partition.
Convert the generic i2c PMIC init code to use the new da9063 driver.
mx53ppd only:
Correct RTC compatible in device tree.
Enable MXC DM i2c driver.
Define CONFIG_SYS_MALLOC_F_LEN so that DM is available in pre-reloc.
Make GPIO banks available during preloc, since initialisation is done
in board_early_init_f().
Add gpio_request() calls to satisfy the DM_GPIO compatibility API.
Remove unused power configuration.
Signed-off-by: Robert Beckett <bob.beckett@collabora.com>
Signed-off-by: Ian Ray <ian.ray@ge.com>
diff --git a/configs/mx53ppd_defconfig b/configs/mx53ppd_defconfig
index b0d3f50..55889ee 100644
--- a/configs/mx53ppd_defconfig
+++ b/configs/mx53ppd_defconfig
@@ -2,9 +2,6 @@
CONFIG_ARCH_MX5=y
CONFIG_SYS_TEXT_BASE=0x77800000
CONFIG_TARGET_MX53PPD=y
-CONFIG_SYS_VPD_EEPROM_I2C_ADDR=0x50
-CONFIG_SYS_VPD_EEPROM_I2C_BUS=2
-CONFIG_SYS_VPD_EEPROM_SIZE=1024
CONFIG_ENV_SIZE=0x2800
CONFIG_ENV_OFFSET=0xC0000
CONFIG_BOOTCOUNT_BOOTLIMIT=10
@@ -41,6 +38,13 @@
CONFIG_BOOTCOUNT_LIMIT=y
CONFIG_BOOTCOUNT_EXT=y
CONFIG_SYS_BOOTCOUNT_EXT_DEVPART="0:5"
+CONFIG_DM_GPIO=y
+CONFIG_DM_I2C=y
+CONFIG_SYS_I2C_MXC=y
+CONFIG_I2C_MUX=y
+CONFIG_I2C_MUX_PCA954x=y
+CONFIG_MISC=y
+CONFIG_I2C_EEPROM=y
CONFIG_DM_MMC=y
CONFIG_FSL_ESDHC_IMX=y
CONFIG_MTD=y
@@ -49,6 +53,7 @@
CONFIG_PINCTRL_IMX5=y
CONFIG_DM_REGULATOR=y
CONFIG_PWM_IMX=y
+CONFIG_DM_RTC=y
CONFIG_RTC_S35392A=y
CONFIG_SYSRESET=y
CONFIG_SYSRESET_WATCHDOG=y
@@ -60,3 +65,4 @@
# CONFIG_VIDEO_SW_CURSOR is not set
CONFIG_WATCHDOG_TIMEOUT_MSECS=8000
CONFIG_IMX_WATCHDOG=y
+CONFIG_SYS_MALLOC_F_LEN=0x4000