regulator: bd718x7: support ROHM BD71837 and BD71847 PMICs
BD71837 and BD71847 is PMIC intended for powering single-core,
dual-core, and quad-core SoC’s such as NXP-i.MX 8M. BD71847
is used for example on NXP imx8mm EVK.
Add regulator driver for ROHM BD71837 and BD71847 PMICs.
BD71837 contains 8 bucks and 7 LDOS. BD71847 is reduced
version containing 6 bucks and 6 LDOs. Voltages for DVS
bucks (1-4 on BD71837, 1 and 2 on BD71847) can be adjusted
when regulators are enabled. For other bucks and LDOs we may
have over- or undershooting if voltage is adjusted when
regulator is enabled. Thus this is prevented by default.
BD718x7 has a quirk which may leave power output disabled
after reset if enable/disable state was controlled by SW.
Thus the SW control is only allowed for BD71837 bucks
3 and 4 by default. The impact of this limitation must be
evaluated board-by board and restrictions may need to be
modified. (Linux driver get's these limitations from DT and we
may want to implement same on u-Boot driver).
Signed-off-by: Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
diff --git a/drivers/power/regulator/Makefile b/drivers/power/regulator/Makefile
index e728b73..6a3d4bb 100644
--- a/drivers/power/regulator/Makefile
+++ b/drivers/power/regulator/Makefile
@@ -9,6 +9,7 @@
obj-$(CONFIG_REGULATOR_AS3722) += as3722_regulator.o
obj-$(CONFIG_DM_REGULATOR_MAX77686) += max77686.o
obj-$(CONFIG_$(SPL_)DM_PMIC_PFUZE100) += pfuze100.o
+obj-$(CONFIG_$(SPL_)DM_REGULATOR_BD71837) += bd71837.o
obj-$(CONFIG_$(SPL_)REGULATOR_PWM) += pwm_regulator.o
obj-$(CONFIG_$(SPL_)DM_REGULATOR_FAN53555) += fan53555.o
obj-$(CONFIG_$(SPL_)DM_REGULATOR_COMMON) += regulator_common.o