mpc83xx: Kconfig: Migrate HRCW to Kconfig
The HRCW (hardware reset configuration word) is a constant that must be
hard-coded into the boot loader image. So, it must be available at
compile time, and cannot be migrated to the DT mechanism, but has to be
kept in Kconfig.
Configuration of this crucial variable should still be somewhat
comfortable. Hence, make its fields configurable in Kconfig, and
assemble the final value from these.
Signed-off-by: Mario Six <mario.six@gdsys.cc>
diff --git a/configs/MPC8349EMDS_SLAVE_defconfig b/configs/MPC8349EMDS_SLAVE_defconfig
index 11e3b14..b0cb93b 100644
--- a/configs/MPC8349EMDS_SLAVE_defconfig
+++ b/configs/MPC8349EMDS_SLAVE_defconfig
@@ -3,6 +3,15 @@
CONFIG_SYS_CLK_FREQ=66666666
CONFIG_MPC83xx=y
CONFIG_TARGET_MPC8349EMDS=y
+CONFIG_DDR_MC_CLOCK_MODE_1_1=y
+CONFIG_SYSTEM_PLL_FACTOR_4_1=y
+CONFIG_CORE_PLL_RATIO_2_1=y
+CONFIG_PCI_64BIT_MODE_ENABLE=y
+CONFIG_BOOT_MEMORY_SPACE_LOW=y
+CONFIG_BOOT_ROM_INTERFACE_GPCM_16BIT=y
+CONFIG_TSEC1_MODE_GMII=y
+CONFIG_TSEC2_MODE_GMII=y
+CONFIG_PCI_ONE_PCI1=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_OF_STDOUT_VIA_ALIAS=y
CONFIG_SYS_EXTRA_OPTIONS="PCISLAVE"
@@ -19,7 +28,8 @@
CONFIG_FLASH_CFI_DRIVER=y
CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
CONFIG_SYS_FLASH_CFI=y
-CONFIG_PHYLIB=y
+CONFIG_NETDEVICES=y
+CONFIG_TSEC_ENET=y
# CONFIG_PCI is not set
CONFIG_SYS_NS16550=y
CONFIG_OF_LIBFDT=y