TQM5200: Call usb_cpu_init() during board init
usb_cpu_init() configures GPS USB pins, clocks, etc. and
is required for proper operation of kernel USB subsystem.
This setup was previously done in the kernel by the fixup
code which is being removed, thus low level init must be
done by U-boot now.
Signed-off-by: Marian Balakowicz <m8@semihalf.com>
Signed-off-by: Markus Klotzbuecher <mk@denx.de>
diff --git a/board/tqm5200/tqm5200.c b/board/tqm5200/tqm5200.c
index d10cb59..da4e228 100644
--- a/board/tqm5200/tqm5200.c
+++ b/board/tqm5200/tqm5200.c
@@ -441,15 +441,21 @@
}
#endif /* CONFIG_POST || CONFIG_LOGBUFFER*/
-#ifdef CONFIG_PS2MULT
#ifdef CONFIG_BOARD_EARLY_INIT_R
int board_early_init_r (void)
{
+#ifdef CONFIG_PS2MULT
ps2mult_early_init();
+#endif /* CONFIG_PS2MULT */
+
+#if defined(CONFIG_USB_OHCI_NEW) && defined(CFG_USB_OHCI_CPU_INIT)
+ /* Low level USB init, required for proper kernel operation */
+ usb_cpu_init();
+#endif
+
return (0);
}
#endif
-#endif /* CONFIG_PS2MULT */
#ifdef CONFIG_FO300
int silent_boot (void)