fix: env: Fix the SPI flash device setup for DM mode
For some reason the spi_flash_probe_bus_cs() is called
inside the setup_flash_device() with zero values in place
of configurated SPI flash mode and maximum flash speed.
This code causes HALT error during startup environment
relocation on some platforms - namely Armada-38x-GP board.
Fix the function call by replacing zeros with the appropriate
values - CONFIG_ENV_SPI_MAX_HZ and CONFIG_ENV_SPI_MODE.
Signed-off-by: Konstantin Porotchkin <kostap@marvell.com>
Cc: Igal Liberman <igall@marvell.com>
Cc: Stefan Roese <sr@denx.de>
Signed-off-by: Stefan Roese <sr@denx.de>
diff --git a/env/sf.c b/env/sf.c
index 4945105..2e3c600 100644
--- a/env/sf.c
+++ b/env/sf.c
@@ -58,7 +58,8 @@
/* speed and mode will be read from DT */
ret = spi_flash_probe_bus_cs(CONFIG_ENV_SPI_BUS, CONFIG_ENV_SPI_CS,
- 0, 0, &new);
+ CONFIG_ENV_SPI_MAX_HZ, CONFIG_ENV_SPI_MODE,
+ &new);
if (ret) {
set_default_env("spi_flash_probe_bus_cs() failed", 0);
return ret;