mmc: set correct block size value in bfin sdh driver
Wait data transfer till the data end bit other than the data block end
bit is set.
Acked-by: Pantelis Antoniou <panto@antoniou-consulting.com>
Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
diff --git a/drivers/mmc/bfin_sdh.c b/drivers/mmc/bfin_sdh.c
index bcd6a3e..9bdfbbc 100644
--- a/drivers/mmc/bfin_sdh.c
+++ b/drivers/mmc/bfin_sdh.c
@@ -138,9 +138,9 @@
if (data->flags & MMC_DATA_WRITE)
return UNUSABLE_ERR;
#ifndef RSI_BLKSZ
- data_ctl |= ((ffs(data_size) - 1) << 4);
+ data_ctl |= ((ffs(data->blocksize) - 1) << 4);
#else
- bfin_write_SDH_BLK_SIZE(data_size);
+ bfin_write_SDH_BLK_SIZE(data->blocksize);
#endif
data_ctl |= DTX_DIR;
bfin_write_SDH_DATA_CTL(data_ctl);
@@ -189,7 +189,8 @@
do {
udelay(1);
status = bfin_read_SDH_STATUS();
- } while (!(status & (DAT_BLK_END | DAT_END | DAT_TIME_OUT | DAT_CRC_FAIL | RX_OVERRUN)));
+ } while (!(status & (DAT_END | DAT_TIME_OUT | DAT_CRC_FAIL |
+ RX_OVERRUN)));
if (status & DAT_TIME_OUT) {
bfin_write_SDH_STATUS_CLR(DAT_TIMEOUT_STAT);