OMAP3: CM-T35: Use generic MMC driver
Switch from the legacy omap3 mmc driver to the new generic omap hsmmc
driver. This patch is based on the work done for Beagle, etc.
Signed-off-by: Tom Rini <trini@ti.com>
Signed-off-by: Sandeep Paulraj <s-paulraj@ti.com>
diff --git a/board/cm_t35/cm_t35.c b/board/cm_t35/cm_t35.c
index f82111b..420cd70 100644
--- a/board/cm_t35/cm_t35.c
+++ b/board/cm_t35/cm_t35.c
@@ -313,6 +313,14 @@
cm_t3730_set_muxconf();
}
+#ifdef CONFIG_GENERIC_MMC
+int board_mmc_init(bd_t *bis)
+{
+ omap_mmc_init(0);
+ return 0;
+}
+#endif
+
/*
* Routine: setup_net_chip_gmpc
* Description: Setting up the configuration GPMC registers specific to the
diff --git a/include/configs/cm_t35.h b/include/configs/cm_t35.h
index 16a5f5b..496a904 100644
--- a/include/configs/cm_t35.h
+++ b/include/configs/cm_t35.h
@@ -108,8 +108,9 @@
#define CONFIG_BAUDRATE 115200
#define CONFIG_SYS_BAUDRATE_TABLE {4800, 9600, 19200, 38400, 57600,\
115200}
+#define CONFIG_GENERIC_MMC 1
#define CONFIG_MMC 1
-#define CONFIG_OMAP3_MMC 1
+#define CONFIG_OMAP_HSMMC 1
#define CONFIG_DOS_PARTITION 1
/* DDR - I use Micron DDR */