arm64: zynqmp: Use ethernet-phy as node name for ethernet phys
Ethernet phys based on devicetree specification should be using
ethernet-phy@ node name instead of pure phy@.
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
diff --git a/arch/arm/dts/zynqmp-zcu104-revC.dts b/arch/arm/dts/zynqmp-zcu104-revC.dts
index 7df16b0..8d8cabf 100644
--- a/arch/arm/dts/zynqmp-zcu104-revC.dts
+++ b/arch/arm/dts/zynqmp-zcu104-revC.dts
@@ -55,7 +55,7 @@
status = "okay";
phy-handle = <&phy0>;
phy-mode = "rgmii-id";
- phy0: phy@c {
+ phy0: ethernet-phy@c {
reg = <0xc>;
ti,rx-internal-delay = <0x8>;
ti,tx-internal-delay = <0xa>;