ARM: dts: sync Amlogic ARM64 DT from v6.2-rc1
This syncs the Amlogic G12A, G12B & SM1 base DT + the
Odroid Go Ultra DT from Linux v6.2-rc1 from commmit [1].
[1] 1b929c02afd3 ("Linux 6.2-rc1")
Link: https://lore.kernel.org/r/20230119-u-boot-odroid-go-ultra-v1-1-f96bab9db396@linaro.org
Signed-off-by: Neil Armstrong <neil.armstrong@linaro.org>
diff --git a/arch/arm/dts/meson-g12-common.dtsi b/arch/arm/dts/meson-g12-common.dtsi
index 00c6f53..9dbd508 100644
--- a/arch/arm/dts/meson-g12-common.dtsi
+++ b/arch/arm/dts/meson-g12-common.dtsi
@@ -58,7 +58,7 @@
secure-monitor = <&sm>;
};
- gpu_opp_table: gpu-opp-table {
+ gpu_opp_table: opp-table-gpu {
compatible = "operating-points-v2";
opp-124999998 {
@@ -107,6 +107,12 @@
no-map;
};
+ /* 32 MiB reserved for ARM Trusted Firmware (BL32) */
+ secmon_reserved_bl32: secmon@5300000 {
+ reg = <0x0 0x05300000 0x0 0x2000000>;
+ no-map;
+ };
+
linux,cma {
compatible = "shared-dma-pool";
reusable;
@@ -159,61 +165,6 @@
status = "disabled";
};
- thermal-zones {
- cpu_thermal: cpu-thermal {
- polling-delay = <1000>;
- polling-delay-passive = <100>;
- thermal-sensors = <&cpu_temp>;
-
- trips {
- cpu_passive: cpu-passive {
- temperature = <85000>; /* millicelsius */
- hysteresis = <2000>; /* millicelsius */
- type = "passive";
- };
-
- cpu_hot: cpu-hot {
- temperature = <95000>; /* millicelsius */
- hysteresis = <2000>; /* millicelsius */
- type = "hot";
- };
-
- cpu_critical: cpu-critical {
- temperature = <110000>; /* millicelsius */
- hysteresis = <2000>; /* millicelsius */
- type = "critical";
- };
- };
- };
-
- ddr_thermal: ddr-thermal {
- polling-delay = <1000>;
- polling-delay-passive = <100>;
- thermal-sensors = <&ddr_temp>;
-
- trips {
- ddr_passive: ddr-passive {
- temperature = <85000>; /* millicelsius */
- hysteresis = <2000>; /* millicelsius */
- type = "passive";
- };
-
- ddr_critical: ddr-critical {
- temperature = <110000>; /* millicelsius */
- hysteresis = <2000>; /* millicelsius */
- type = "critical";
- };
- };
-
- cooling-maps {
- map {
- trip = <&ddr_passive>;
- cooling-device = <&mali THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
- };
- };
- };
- };
-
ethmac: ethernet@ff3f0000 {
compatible = "amlogic,meson-g12a-dwmac",
"snps,dwmac-3.70a",
@@ -894,6 +845,22 @@
};
};
+ pwm_f_z_pins: pwm-f-z {
+ mux {
+ groups = "pwm_f_z";
+ function = "pwm_f";
+ bias-disable;
+ };
+ };
+
+ pwm_f_a_pins: pwm-f-a {
+ mux {
+ groups = "pwm_f_a";
+ function = "pwm_f";
+ bias-disable;
+ };
+ };
+
pwm_f_x_pins: pwm-f-x {
mux {
groups = "pwm_f_x";
@@ -1738,6 +1705,12 @@
};
};
+ pmu: pmu@ff638000 {
+ reg = <0x0 0xff638000 0x0 0x100>,
+ <0x0 0xff638c00 0x0 0x100>;
+ interrupts = <GIC_SPI 52 IRQ_TYPE_EDGE_RISING>;
+ };
+
aobus: bus@ff800000 {
compatible = "simple-bus";
reg = <0x0 0xff800000 0x0 0x100000>;
@@ -1936,6 +1909,33 @@
};
};
+ uart_ao_b_2_3_pins: uart-ao-b-2-3 {
+ mux {
+ groups = "uart_ao_b_tx_2",
+ "uart_ao_b_rx_3";
+ function = "uart_ao_b";
+ bias-disable;
+ };
+ };
+
+ uart_ao_b_8_9_pins: uart-ao-b-8-9 {
+ mux {
+ groups = "uart_ao_b_tx_8",
+ "uart_ao_b_rx_9";
+ function = "uart_ao_b";
+ bias-disable;
+ };
+ };
+
+ uart_ao_b_cts_rts_pins: uart-ao-b-cts-rts {
+ mux {
+ groups = "uart_ao_b_cts",
+ "uart_ao_b_rts";
+ function = "uart_ao_b";
+ bias-disable;
+ };
+ };
+
pwm_a_e_pins: pwm-a-e {
mux {
groups = "pwm_a_e";
@@ -2415,6 +2415,61 @@
};
};
+ thermal-zones {
+ cpu_thermal: cpu-thermal {
+ polling-delay = <1000>;
+ polling-delay-passive = <100>;
+ thermal-sensors = <&cpu_temp>;
+
+ trips {
+ cpu_passive: cpu-passive {
+ temperature = <85000>; /* millicelsius */
+ hysteresis = <2000>; /* millicelsius */
+ type = "passive";
+ };
+
+ cpu_hot: cpu-hot {
+ temperature = <95000>; /* millicelsius */
+ hysteresis = <2000>; /* millicelsius */
+ type = "hot";
+ };
+
+ cpu_critical: cpu-critical {
+ temperature = <110000>; /* millicelsius */
+ hysteresis = <2000>; /* millicelsius */
+ type = "critical";
+ };
+ };
+ };
+
+ ddr_thermal: ddr-thermal {
+ polling-delay = <1000>;
+ polling-delay-passive = <100>;
+ thermal-sensors = <&ddr_temp>;
+
+ trips {
+ ddr_passive: ddr-passive {
+ temperature = <85000>; /* millicelsius */
+ hysteresis = <2000>; /* millicelsius */
+ type = "passive";
+ };
+
+ ddr_critical: ddr-critical {
+ temperature = <110000>; /* millicelsius */
+ hysteresis = <2000>; /* millicelsius */
+ type = "critical";
+ };
+ };
+
+ cooling-maps {
+ map {
+ trip = <&ddr_passive>;
+ cooling-device = <&mali THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
+ };
+ };
+ };
+ };
+
timer {
compatible = "arm,armv8-timer";
interrupts = <GIC_PPI 13