spi: davinci: add support for multiple bus and chip select
Currently davinci spi driver supports only bus 0 cs 0.
This patch allows driver to support bus 1 and bus 2 with
configurable number of chip selects. Also defaults are
selected in a way to avoid regression on other platforms
that uses davinci spi driver and has only one spi bus.
Signed-off-by: Rex Chang <rchang@ti.com>
Signed-off-by: Murali Karicheri <m-karicheri2@ti.com>
Reviewed-by: Jagannadha Sutradharudu Teki <jaganna@xilinx.com>
diff --git a/drivers/spi/davinci_spi.h b/drivers/spi/davinci_spi.h
index 33f69b5..d4612d3 100644
--- a/drivers/spi/davinci_spi.h
+++ b/drivers/spi/davinci_spi.h
@@ -74,6 +74,39 @@
/* SPIDEF */
#define SPIDEF_CSDEF0_MASK BIT(0)
+#define SPI0_BUS 0
+#define SPI0_BASE CONFIG_SYS_SPI_BASE
+/*
+ * Define default SPI0_NUM_CS as 1 for existing platforms that uses this
+ * driver. Platform can configure number of CS using CONFIG_SYS_SPI0_NUM_CS
+ * if more than one CS is supported and by defining CONFIG_SYS_SPI0.
+ */
+#ifndef CONFIG_SYS_SPI0
+#define SPI0_NUM_CS 1
+#else
+#define SPI0_NUM_CS CONFIG_SYS_SPI0_NUM_CS
+#endif
+
+/*
+ * define CONFIG_SYS_SPI1 when platform has spi-1 device (bus #1) and
+ * CONFIG_SYS_SPI1_NUM_CS defines number of CS on this bus
+ */
+#ifdef CONFIG_SYS_SPI1
+#define SPI1_BUS 1
+#define SPI1_NUM_CS CONFIG_SYS_SPI1_NUM_CS
+#define SPI1_BASE CONFIG_SYS_SPI1_BASE
+#endif
+
+/*
+ * define CONFIG_SYS_SPI2 when platform has spi-2 device (bus #2) and
+ * CONFIG_SYS_SPI2_NUM_CS defines number of CS on this bus
+ */
+#ifdef CONFIG_SYS_SPI2
+#define SPI2_BUS 2
+#define SPI2_NUM_CS CONFIG_SYS_SPI2_NUM_CS
+#define SPI2_BASE CONFIG_SYS_SPI2_BASE
+#endif
+
struct davinci_spi_slave {
struct spi_slave slave;
struct davinci_spi_regs *regs;