power: pwm_regulator: remove redundant code
The regulator_enable() should be called from upper layer like
regulators_enable_boot_on(), remove it from pwm regulator driver.
Signed-off-by: Kever Yang <kever.yang@rock-chips.com>
Acked-by: Philipp Tomsich <philipp.tomsich@theobroma-systems.com>
Reviewed-by: Philipp Tomsich <philipp.tomsich@theobroma-systems.com>
[fixed up typo in commit message:]
Signed-off-by: Philipp Tomsich <philipp.tomsich@theobroma-systems.com>
diff --git a/drivers/power/regulator/pwm_regulator.c b/drivers/power/regulator/pwm_regulator.c
index fcf5e00..b63f941 100644
--- a/drivers/power/regulator/pwm_regulator.c
+++ b/drivers/power/regulator/pwm_regulator.c
@@ -86,12 +86,8 @@
return ret;
}
- ret = pwm_set_enable(priv->pwm, priv->pwm_id, true);
- if (ret) {
- dev_err(dev, "Failed to enable PWM\n");
- return ret;
- }
priv->volt_uV = uvolt;
+
return ret;
}
@@ -144,8 +140,6 @@
if (priv->init_voltage)
pwm_regulator_set_voltage(dev, priv->init_voltage);
- pwm_regulator_enable(dev, 1);
-
return 0;
}