sf: Add quad read/write commands support
This patch add quad commands support like
- QUAD_PAGE_PROGRAM => for write program
- QUAD_OUTPUT_FAST ->> for read program
Signed-off-by: Jagannadha Sutradharudu Teki <jaganna@xilinx.com>
diff --git a/include/spi.h b/include/spi.h
index 31195a3..5dd490a 100644
--- a/include/spi.h
+++ b/include/spi.h
@@ -31,11 +31,16 @@
#define SPI_XFER_MMAP_END 0x10 /* Memory Mapped End */
#define SPI_XFER_ONCE (SPI_XFER_BEGIN | SPI_XFER_END)
+/* SPI TX operation modes */
+#define SPI_OPM_TX_QPP 1 << 0
+
/* SPI RX operation modes */
#define SPI_OPM_RX_AS 1 << 0
#define SPI_OPM_RX_DOUT 1 << 1
#define SPI_OPM_RX_DIO 1 << 2
-#define SPI_OPM_RX_EXTN SPI_OPM_RX_AS | SPI_OPM_RX_DOUT | SPI_OPM_RX_DIO
+#define SPI_OPM_RX_QOF 1 << 3
+#define SPI_OPM_RX_EXTN SPI_OPM_RX_AS | SPI_OPM_RX_DOUT | \
+ SPI_OPM_RX_DIO | SPI_OPM_RX_QOF
/* Header byte that marks the start of the message */
#define SPI_PREAMBLE_END_BYTE 0xec
@@ -50,6 +55,7 @@
* @bus: ID of the bus that the slave is attached to.
* @cs: ID of the chip select connected to the slave.
* @op_mode_rx: SPI RX operation mode.
+ * @op_mode_tx: SPI TX operation mode.
* @wordlen: Size of SPI word in number of bits
* @max_write_size: If non-zero, the maximum number of bytes which can
* be written at once, excluding command bytes.
@@ -59,6 +65,7 @@
unsigned int bus;
unsigned int cs;
u8 op_mode_rx;
+ u8 op_mode_tx;
unsigned int wordlen;
unsigned int max_write_size;
void *memory_map;