MMC: Consolidate MMC/SD command definitions
This moves the MMC and SD Card command definitions from
include/asm/arch/mmc.h into include/mmc.h. These definitions are
given by the MMC and SD Card standards, not by any particular
architecture.
There's a lot more room for consolidation in the MMC drivers which
I'm hoping to get done eventually, but this patch is a start.
Compile-tested for all avr32 boards as well as lpc2292sodimm and
lubbock. This should cover all three mmc drivers in the tree.
Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
diff --git a/include/mmc.h b/include/mmc.h
index a271695..19c76fe 100644
--- a/include/mmc.h
+++ b/include/mmc.h
@@ -25,6 +25,30 @@
#define _MMC_H_
#include <asm/arch/mmc.h>
+/* MMC command numbers */
+#define MMC_CMD_GO_IDLE_STATE 0
+#define MMC_CMD_SEND_OP_COND 1
+#define MMC_CMD_ALL_SEND_CID 2
+#define MMC_CMD_SET_RELATIVE_ADDR 3
+#define MMC_CMD_SET_DSR 4
+#define MMC_CMD_SELECT_CARD 7
+#define MMC_CMD_SEND_CSD 9
+#define MMC_CMD_SEND_CID 10
+#define MMC_CMD_SEND_STATUS 13
+#define MMC_CMD_SET_BLOCKLEN 16
+#define MMC_CMD_READ_SINGLE_BLOCK 17
+#define MMC_CMD_READ_MULTIPLE_BLOCK 18
+#define MMC_CMD_WRITE_BLOCK 24
+#define MMC_CMD_APP_CMD 55
+
+/* SD Card command numbers */
+#define SD_CMD_SEND_RELATIVE_ADDR 3
+#define SD_CMD_SWITCH 6
+#define SD_CMD_SEND_IF_COND 8
+
+#define SD_CMD_APP_SET_BUS_WIDTH 6
+#define SD_CMD_APP_SEND_OP_COND 41
+
int mmc_init(int verbose);
int mmc_read(ulong src, uchar *dst, int size);
int mmc_write(uchar *src, ulong dst, int size);