phy: Extend generic_setup_phy() with PHY mode and submode
Extend generic_setup_phy() parameter list with PHY mode and submode and
call generic_phy_set_mode() in generic_setup_phy(), so the generic PHY
setup function can configure the PHY into correct mode before powering
the PHY up.
Update all call sites of generic_setup_phy() as well, all of which are
USB host related, except for DM test which now behaves as a USB host
test.
Note that if the PHY driver does not implement the .set_mode callback,
generic_phy_set_mode() call returns 0 and does not error out, so this
should not break any existing systems.
Reviewed-by: Mattijs Korpershoek <mkorpershoek@baylibre.com>
Signed-off-by: Marek Vasut <marek.vasut+renesas@mailbox.org>
diff --git a/drivers/usb/host/ehci-mx6.c b/drivers/usb/host/ehci-mx6.c
index 31cd8a5..a93fa5d 100644
--- a/drivers/usb/host/ehci-mx6.c
+++ b/drivers/usb/host/ehci-mx6.c
@@ -703,7 +703,7 @@
usb_phy_enable(ehci, priv->phy_addr);
#endif
#else
- ret = generic_setup_phy(dev, &priv->phy, 0);
+ ret = generic_setup_phy(dev, &priv->phy, 0, PHY_MODE_USB_HOST, 0);
if (ret)
goto err_regulator;
#endif