drivers/pinctrl/rockchip/pinctrl-rockchip.h

/* SPDX-License-Identifier: GPL-2.0+ */
/*
 * (C) Copyright 2019 Rockchip Electronics Co., Ltd
 */

#ifndef __DRIVERS_PINCTRL_ROCKCHIP_H
#define __DRIVERS_PINCTRL_ROCKCHIP_H

#include <linux/types.h>

enum rockchip_pinctrl_type {
	RV1108,
	RK3036,
	RK3128,
	RK3188,
	RK3288,
	RK3368,
	RK3399,
};

/**
 * Encode variants of iomux registers into a type variable
 */
#define IOMUX_GPIO_ONLY		BIT(0)
#define IOMUX_WIDTH_4BIT	BIT(1)
#define IOMUX_SOURCE_PMU	BIT(2)
#define IOMUX_UNROUTED		BIT(3)
#define IOMUX_WIDTH_3BIT	BIT(4)

/**
 * Defined some common pins constants
 */
#define ROCKCHIP_PULL_BITS_PER_PIN	2
#define ROCKCHIP_PULL_PINS_PER_REG	8
#define ROCKCHIP_PULL_BANK_STRIDE	16
#define ROCKCHIP_DRV_BITS_PER_PIN	2
#define ROCKCHIP_DRV_PINS_PER_REG	8
#define ROCKCHIP_DRV_BANK_STRIDE	16
#define ROCKCHIP_DRV_3BITS_PER_PIN	3

/**
 * @type: iomux variant using IOMUX_* constants
 * @offset: if initialized to -1 it will be autocalculated, by specifying
 *	    an initial offset value the relevant source offset can be reset
 *	    to a new value for autocalculating the following iomux registers.
 */
struct rockchip_iomux {
	int				type;
	int				offset;
};

/**
 * enum type index corresponding to rockchip_perpin_drv_list arrays index.
 */
enum rockchip_pin_drv_type {
	DRV_TYPE_IO_DEFAULT = 0,
	DRV_TYPE_IO_1V8_OR_3V0,
	DRV_TYPE_IO_1V8_ONLY,
	DRV_TYPE_IO_1V8_3V0_AUTO,
	DRV_TYPE_IO_3V3_ONLY,
	DRV_TYPE_MAX
};

/**
 * enum type index corresponding to rockchip_pull_list arrays index.
 */
enum rockchip_pin_pull_type {
	PULL_TYPE_IO_DEFAULT = 0,
	PULL_TYPE_IO_1V8_ONLY,
	PULL_TYPE_MAX
};

/**
 * @drv_type: drive strength variant using rockchip_perpin_drv_type
 * @offset: if initialized to -1 it will be autocalculated, by specifying
 *	    an initial offset value the relevant source offset can be reset
 *	    to a new value for autocalculating the following drive strength
 *	    registers. if used chips own cal_drv func instead to calculate
 *	    registers offset, the variant could be ignored.
 */
struct rockchip_drv {
	enum rockchip_pin_drv_type	drv_type;
	int				offset;
};

/**
 * @priv: common pinctrl private basedata
 * @pin_base: first pin number
 * @nr_pins: number of pins in this bank
 * @name: name of the bank
 * @bank_num: number of the bank, to account for holes
 * @iomux: array describing the 4 iomux sources of the bank
 * @drv: array describing the 4 drive strength sources of the bank
 * @pull_type: array describing the 4 pull type sources of the bank
 * @recalced_mask: bits describing the mux recalced pins of per bank
 * @route_mask: bits describing the routing pins of per bank
 */
struct rockchip_pin_bank {
	struct rockchip_pinctrl_priv	*priv;
	u32				pin_base;
	u8				nr_pins;
	char				*name;
	u8				bank_num;
	struct rockchip_iomux		iomux[4];
	struct rockchip_drv		drv[4];
	enum rockchip_pin_pull_type	pull_type[4];
	u32				recalced_mask;
	u32				route_mask;
};

#define PIN_BANK(id, pins, label)			\
	{						\
		.bank_num	= id,			\
		.nr_pins	= pins,			\
		.name		= label,		\
		.iomux		= {			\
			{ .offset = -1 },		\
			{ .offset = -1 },		\
			{ .offset = -1 },		\
			{ .offset = -1 },		\
		},					\
	}

#define PIN_BANK_IOMUX_FLAGS(id, pins, label, iom0, iom1, iom2, iom3)	\
	{								\
		.bank_num	= id,					\
		.nr_pins	= pins,					\
		.name		= label,				\
		.iomux		= {					\
			{ .type = iom0, .offset = -1 },			\
			{ .type = iom1, .offset = -1 },			\
			{ .type = iom2, .offset = -1 },			\
			{ .type = iom3, .offset = -1 },			\
		},							\
	}

#define PIN_BANK_DRV_FLAGS(id, pins, label, type0, type1, type2, type3) \
	{								\
		.bank_num	= id,					\
		.nr_pins	= pins,					\
		.name		= label,				\
		.iomux		= {					\
			{ .offset = -1 },				\
			{ .offset = -1 },				\
			{ .offset = -1 },				\
			{ .offset = -1 },				\
		},							\
		.drv		= {					\
			{ .drv_type = type0, .offset = -1 },		\
			{ .drv_type = type1, .offset = -1 },		\
			{ .drv_type = type2, .offset = -1 },		\
			{ .drv_type = type3, .offset = -1 },		\
		},							\
	}

#define PIN_BANK_DRV_FLAGS_PULL_FLAGS(id, pins, label, drv0, drv1,	\
				      drv2, drv3, pull0, pull1,		\
				      pull2, pull3)			\
	{								\
		.bank_num	= id,					\
		.nr_pins	= pins,					\
		.name		= label,				\
		.iomux		= {					\
			{ .offset = -1 },				\
			{ .offset = -1 },				\
			{ .offset = -1 },				\
			{ .offset = -1 },				\
		},							\
		.drv		= {					\
			{ .drv_type = drv0, .offset = -1 },		\
			{ .drv_type = drv1, .offset = -1 },		\
			{ .drv_type = drv2, .offset = -1 },		\
			{ .drv_type = drv3, .offset = -1 },		\
		},							\
		.pull_type[0] = pull0,					\
		.pull_type[1] = pull1,					\
		.pull_type[2] = pull2,					\
		.pull_type[3] = pull3,					\
	}

#define PIN_BANK_IOMUX_DRV_FLAGS_OFFSET(id, pins, label, iom0, iom1,	\
					iom2, iom3, drv0, drv1, drv2,	\
					drv3, offset0, offset1,		\
					offset2, offset3)		\
	{								\
		.bank_num	= id,					\
		.nr_pins	= pins,					\
		.name		= label,				\
		.iomux		= {					\
			{ .type = iom0, .offset = -1 },			\
			{ .type = iom1, .offset = -1 },			\
			{ .type = iom2, .offset = -1 },			\
			{ .type = iom3, .offset = -1 },			\
		},							\
		.drv		= {					\
			{ .drv_type = drv0, .offset = offset0 },	\
			{ .drv_type = drv1, .offset = offset1 },	\
			{ .drv_type = drv2, .offset = offset2 },	\
			{ .drv_type = drv3, .offset = offset3 },	\
		},							\
	}

#define PIN_BANK_IOMUX_FLAGS_DRV_FLAGS_OFFSET_PULL_FLAGS(id, pins,	\
					      label, iom0, iom1, iom2,  \
					      iom3, drv0, drv1, drv2,   \
					      drv3, offset0, offset1,   \
					      offset2, offset3, pull0,  \
					      pull1, pull2, pull3)	\
	{								\
		.bank_num	= id,					\
		.nr_pins	= pins,					\
		.name		= label,				\
		.iomux		= {					\
			{ .type = iom0, .offset = -1 },			\
			{ .type = iom1, .offset = -1 },			\
			{ .type = iom2, .offset = -1 },			\
			{ .type = iom3, .offset = -1 },			\
		},							\
		.drv		= {					\
			{ .drv_type = drv0, .offset = offset0 },	\
			{ .drv_type = drv1, .offset = offset1 },	\
			{ .drv_type = drv2, .offset = offset2 },	\
			{ .drv_type = drv3, .offset = offset3 },	\
		},							\
		.pull_type[0] = pull0,					\
		.pull_type[1] = pull1,					\
		.pull_type[2] = pull2,					\
		.pull_type[3] = pull3,					\
	}

/**
 * struct rockchip_mux_recalced_data: recalculate a pin iomux data.
 * @num: bank number.
 * @pin: pin number.
 * @reg: register offset.
 * @bit: index at register.
 * @mask: mask bit
 */
struct rockchip_mux_recalced_data {
	u8 num;
	u8 pin;
	u32 reg;
	u8 bit;
	u8 mask;
};

/**
 * struct rockchip_mux_route_data: route a pin iomux data.
 * @bank_num: bank number.
 * @pin: index at register or used to calc index.
 * @func: the min pin.
 * @route_offset: the max pin.
 * @route_val: the register offset.
 */
struct rockchip_mux_route_data {
	u8 bank_num;
	u8 pin;
	u8 func;
	u32 route_offset;
	u32 route_val;
};

/**
 */
struct rockchip_pin_ctrl {
	struct rockchip_pin_bank	*pin_banks;
	u32				nr_banks;
	u32				nr_pins;
	char				*label;
	enum rockchip_pinctrl_type	type;
	int				grf_mux_offset;
	int				pmu_mux_offset;
	int				grf_drv_offset;
	int				pmu_drv_offset;
	struct rockchip_mux_recalced_data *iomux_recalced;
	u32				niomux_recalced;
	struct rockchip_mux_route_data *iomux_routes;
	u32				niomux_routes;

	void	(*pull_calc_reg)(struct rockchip_pin_bank *bank,
				 int pin_num, struct regmap **regmap,
				 int *reg, u8 *bit);
	void	(*drv_calc_reg)(struct rockchip_pin_bank *bank,
				int pin_num, struct regmap **regmap,
				int *reg, u8 *bit);
	int	(*schmitt_calc_reg)(struct rockchip_pin_bank *bank,
				    int pin_num, struct regmap **regmap,
				    int *reg, u8 *bit);
};

/**
 */
struct rockchip_pinctrl_priv {
	struct rockchip_pin_ctrl	*ctrl;
	struct regmap			*regmap_base;
	struct regmap			*regmap_pmu;
};

extern const struct pinctrl_ops rockchip_pinctrl_ops;
int rockchip_pinctrl_probe(struct udevice *dev);

#endif /* __DRIVERS_PINCTRL_ROCKCHIP_H */