spi: nxp_fspi: new driver for the FlexSPI controller
This is a port of the kernel's spi-nxp-fspi driver. It uses the new
spi-mem interface and does not expose the more generic spi-xfer
interface. The source was taken from the v5.3-rc3 tag.
The port was straightforward:
- remove the interrupt handling and the completion by busy polling the
controller
- remove locks
- move the setup of the memory windows into claim_bus()
- move the setup of the speed into set_speed()
- port the device tree bindings from the original fspi_probe() to
ofdata_to_platdata()
There were only some style change fixes, no change in any logic. For
example, there are busy loops where the return code is not handled
correctly, eg. only prints a warning with WARN_ON(). This port
intentionally left most functions unchanged to ease future bugfixes.
This was tested on a custom LS1028A board. Because the LS1028A doesn't
have proper clock framework support, changing the clock speed was not
tested. This also means that it is not possible to change the SPI
speed on LS1028A for now (neither is it possible in the linux driver).
Signed-off-by: Michael Walle <michael@walle.cc>
Reviewed-by: Jagan Teki <jagan@amarulasolutions.com>
Tested-by: Kuldeep Singh <kuldeep.singh@nxp.com>
diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index 73d1a69..4166c61 100644
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -192,6 +192,13 @@
used to access the SPI NOR flash on platforms embedding this
Marvell IP core.
+config NXP_FSPI
+ bool "NXP FlexSPI driver"
+ depends on SPI_MEM
+ help
+ Enable the NXP FlexSPI (FSPI) driver. This driver can be used to
+ access the SPI NOR flash on platforms embedding this NXP IP core.
+
config PIC32_SPI
bool "Microchip PIC32 SPI driver"
depends on MACH_PIC32