M28: Add memory detection into SPL
This code allows the DDR DRAM size to be detected at runtime. The RAM size is
stored into two scratch registers, from which it is then fetched in U-Boot.
Signed-off-by: Marek Vasut <marek.vasut@gmail.com>
Cc: Stefano Babic <sbabic@denx.de>
Cc: Wolfgang Denk <wd@denx.de>
Cc: Detlev Zundel <dzu@denx.de>
diff --git a/board/denx/m28evk/Makefile b/board/denx/m28evk/Makefile
index 47229e6..b6f002f 100644
--- a/board/denx/m28evk/Makefile
+++ b/board/denx/m28evk/Makefile
@@ -30,7 +30,7 @@
endif
ifdef CONFIG_SPL_BUILD
-COBJS := mem_init.o mmc_boot.o power_init.o
+COBJS := mem_init.o mmc_boot.o power_init.o memsize.o
endif
SRCS := $(COBJS:.o=.c)
@@ -41,6 +41,11 @@
all: $(ALL)
+ifdef CONFIG_SPL_BUILD
+memsize.c:
+ ln -sf $(TOPDIR)/common/memsize.c $@
+endif
+
#########################################################################
# defines $(obj).depend target