sunxi: R40: add gigabit ethernet devicetree node
Add a device tree node for the Allwinner R40/V40 GMAC gigabit
ethernet interface.
The R40 SoC does not use the syscon register for GMAC settings.
The gigabit ethernet interface can only be routed to a fixed set of
pins.
Updated to match the Linux kernel's device tree.
Signed-off-by: Lothar Felten <lothar.felten@gmail.com>
Acked-by: Maxime Ripard <maxime.ripard@bootlin.com>
Reviewed-by: Jagan Teki <jagan@openedev.com>
Tested-by: Jagan Teki <jagan@openedev.com>
diff --git a/arch/arm/dts/sun8i-r40.dtsi b/arch/arm/dts/sun8i-r40.dtsi
index 0aa76a2..2cdfb54 100644
--- a/arch/arm/dts/sun8i-r40.dtsi
+++ b/arch/arm/dts/sun8i-r40.dtsi
@@ -161,6 +161,19 @@
#interrupt-cells = <3>;
#gpio-cells = <3>;
+ gmac_rgmii_pins: gmac-rgmii-pins {
+ pins = "PA0", "PA1", "PA2", "PA3",
+ "PA4", "PA5", "PA6", "PA7",
+ "PA8", "PA10", "PA11", "PA12",
+ "PA13", "PA15", "PA16";
+ function = "gmac";
+ /*
+ * data lines in RGMII mode use DDR mode
+ * and need a higher signal drive strength
+ */
+ drive-strength = <40>;
+ };
+
i2c0_pins: i2c0_pins {
pins = "PB0", "PB1";
function = "i2c0";
@@ -202,6 +215,27 @@
#size-cells = <0>;
};
+ gmac: ethernet@1c50000 {
+ compatible = "allwinner,sun8i-r40-gmac";
+ syscon = <&ccu>;
+ reg = <0x01c50000 0x10000>;
+ interrupts = <GIC_SPI 85 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "macirq";
+ resets = <&ccu RST_BUS_GMAC>;
+ reset-names = "stmmaceth";
+ clocks = <&ccu CLK_BUS_GMAC>;
+ clock-names = "stmmaceth";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ status = "disabled";
+
+ gmac_mdio: mdio {
+ compatible = "snps,dwmac-mdio";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ };
+ };
+
gic: interrupt-controller@1c81000 {
compatible = "arm,cortex-a7-gic", "arm,cortex-a15-gic";
reg = <0x01c81000 0x1000>,