phy: marvell: cp110: utmi: update analog parameters according to latest ETP
Add UTMI analog parameters initialization values according to
latest ETP.
Change-Id: I5bcca205a3995202a18ff126f371a81f69e205c8
Signed-off-by: Igal Liberman <igall@marvell.com>
diff --git a/drivers/phy/marvell/comphy_cp110.c b/drivers/phy/marvell/comphy_cp110.c
index 82d8693..72563f8 100644
--- a/drivers/phy/marvell/comphy_cp110.c
+++ b/drivers/phy/marvell/comphy_cp110.c
@@ -614,15 +614,12 @@
/* Impedance Calibration Threshold Setting */
reg_set(utmi_base_addr + UTMI_CALIB_CTRL_REG,
- 0x6 << UTMI_CALIB_CTRL_IMPCAL_VTH_OFFSET,
+ 0x7 << UTMI_CALIB_CTRL_IMPCAL_VTH_OFFSET,
UTMI_CALIB_CTRL_IMPCAL_VTH_MASK);
/* Set LS TX driver strength coarse control */
- mask = UTMI_TX_CH_CTRL_DRV_EN_LS_MASK;
- data = 0x3 << UTMI_TX_CH_CTRL_DRV_EN_LS_OFFSET;
- /* Set LS TX driver fine adjustment */
- mask |= UTMI_TX_CH_CTRL_IMP_SEL_LS_MASK;
- data |= 0x3 << UTMI_TX_CH_CTRL_IMP_SEL_LS_OFFSET;
+ mask = UTMI_TX_CH_CTRL_AMP_MASK;
+ data = 0x4 << UTMI_TX_CH_CTRL_AMP_OFFSET;
reg_set(utmi_base_addr + UTMI_TX_CH_CTRL_REG, data, mask);
/* Enable SQ */