clk: renesas: Always select DM_RESET to prevent inobvious failure of rst_gen3 subdriver
The CLK_RCAR_GEN3 registers two subdrivers, clk_gen3 and rst_gen3.
The former depends on the clock framework, which is always enabled
in this context of clock framework driver, while the later depends
on reset framework which may not always be enabled.
Ensure the reset framework is also always enabled to prevent inobvious
early boot time bind failure of the CPG driver, which leads to system
showing no activity and is difficult to debug.
Note that one possible approach to debug this is to use CONFIG_DEBUG_UART
and add debug printascii()s into the drivers/clk/renesas/clk-rcar-gen3.c .
Signed-off-by: Marek Vasut <marek.vasut+renesas@mailbox.org>
diff --git a/drivers/clk/renesas/Kconfig b/drivers/clk/renesas/Kconfig
index 1686410..d58e897 100644
--- a/drivers/clk/renesas/Kconfig
+++ b/drivers/clk/renesas/Kconfig
@@ -49,6 +49,7 @@
def_bool y if RCAR_GEN3
depends on CLK_RENESAS
select CLK_RCAR_CPG_LIB
+ select DM_RESET
help
Enable this to support the clocks on Renesas RCar Gen3 SoC.