MX: serial_mxc: cleanup removing nasty #ifdef
The serial driver for iMX SOCs is continuosly changed if a
new SOC or not yet used port is used. CONFIG_SYS_<SOC>_<UART Port>
defines were used only to find the base address for the selected UART.
Instead of that, move the base address to the board configuration
file and drop all #ifdef from driver.
Signed-off-by: Stefano Babic <sbabic@denx.de>
CC: Marek Vasut <marek.vasut@gmail.com>
CC: Wolfgang Denk <wd@denx.de>
CC: Fabio Estevam <fabio.estevam@freescale.com>
CC: Helmut Raiger <helmut.raiger@hale.at>
CC: John Rigby <jcrigby@gmail.com>
CC: Matthias Weisser <weisserm@arcor.de>
CC: Jason Liu <jason.hui@linaro.org>
Acked-by: Jason Liu <jason.hui@linaro.org>
diff --git a/include/configs/mx51evk.h b/include/configs/mx51evk.h
index 7c7544f..dd53f48 100644
--- a/include/configs/mx51evk.h
+++ b/include/configs/mx51evk.h
@@ -59,7 +59,7 @@
* Hardware drivers
*/
#define CONFIG_MXC_UART
-#define CONFIG_SYS_MX51_UART1
+#define CONFIG_MXC_UART_BASE UART1_BASE
#define CONFIG_MXC_GPIO
/*