Fix problems with SNTP support;
enable SNTP support in some boards.
diff --git a/include/configs/Alaska8220.h b/include/configs/Alaska8220.h
index 5ab6fe6..4927a37 100644
--- a/include/configs/Alaska8220.h
+++ b/include/configs/Alaska8220.h
@@ -58,44 +58,30 @@
#define CONFIG_BAUDRATE 115200 /* ... at 115200 bps */
-
#define CFG_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200, 230400 }
+#define CONFIG_TIMESTAMP /* Print image info with timestamp */
+
/*
* Supported commands
*/
-/* CONFIG_CMD_DFL includes CFG_CMD_BDI (bdinfo), CFG_CMD_LOADS (loads),
- CFG_CMD_LOADB (loadb), CFG_CMD_IMI (iminfo), CFG_CMD_FLASH
- (flinfo, erase, protect), CFG_CMD_MEMORY (md, mm, nm, mw, cp, cmp,
- crc, base, loop, mtest), CFG_CMD_ENV (printenv, setenv, saveenv),
- CFG_CMD_BOOTD (bootd), CFG_CMD_CONSOLE (coninfo), CFG_CMD_NET (bootp,
- tftpboot, rarpboot), CFG_CMD_RUN, CFG_CMD_MISC (sleep, etc),
- CFG_CMD_BSP, CFG_CMD_IMLS, CFG_CMD_FPGA */
+#define CONFIG_COMMANDS ( CONFIG_CMD_DFL | \
+ CFG_CMD_BOOTD | \
+ CFG_CMD_CACHE | \
+ CFG_CMD_DHCP | \
+ CFG_CMD_DIAG | \
+ CFG_CMD_EEPROM | \
+ CFG_CMD_ELF | \
+ CFG_CMD_I2C | \
+ CFG_CMD_NET | \
+ CFG_CMD_NFS | \
+ CFG_CMD_PING | \
+ CFG_CMD_PCI | \
+ CFG_CMD_REGINFO | \
+ CFG_CMD_SDRAM | \
+ CFG_CMD_SNTP )
-#define CONFIG_COMMANDS (CONFIG_CMD_DFL | \
- CFG_CMD_BOOTD | \
- CFG_CMD_CACHE | \
- CFG_CMD_DIAG | \
- CFG_CMD_EEPROM | \
- CFG_CMD_ELF | \
- CFG_CMD_I2C | \
- CFG_CMD_NET | \
- CFG_CMD_PING | \
- CFG_CMD_REGINFO | \
- CFG_CMD_SDRAM \
- )
-/* CFG_CMD_DHCP | \ */
-/* CFG_CMD_MII | \ */
-/* CFG_CMD_PCI | \ */
-/* CFG_CMD_USB */
-
-# define CONFIG_NET_MULTI
-/*#if (CONFIG_COMMANDS & CFG_CMD_NET)
-# define CONFIG_NET_MULTI
-#else
-# undef CONFIG_NET_MULTI
-#endif*/
-
+#define CONFIG_NET_MULTI
/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
#include <cmd_confdefs.h>