Blackfin: drop dead/wrong debug code in initdram()
The DEBUG code in initdram() is quite old and was never really useful, so
just drop it altogether. Common Blackfin debug code does a better job.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
diff --git a/board/bf561-ezkit/bf561-ezkit.c b/board/bf561-ezkit/bf561-ezkit.c
index 7f8598c..5aede17 100644
--- a/board/bf561-ezkit/bf561-ezkit.c
+++ b/board/bf561-ezkit/bf561-ezkit.c
@@ -39,19 +39,7 @@
phys_size_t initdram(int board_type)
{
-#ifdef DEBUG
- int brate;
- char *tmp = getenv("baudrate");
- brate = simple_strtoul(tmp, NULL, 16);
- printf("Serial Port initialized with Baud rate = %x\n", brate);
- printf("SDRAM attributes:\n");
- printf("tRCD %d SCLK Cycles,tRP %d SCLK Cycles,tRAS %d SCLK Cycles"
- "tWR %d SCLK Cycles,CAS Latency %d SCLK cycles \n",
- 3, 3, 6, 2, 3);
- printf("SDRAM Begin: 0x%x\n", CONFIG_SYS_SDRAM_BASE);
- printf("Bank size = %d MB\n", CONFIG_SYS_MAX_RAM_SIZE >> 20);
-#endif
gd->bd->bi_memstart = CONFIG_SYS_SDRAM_BASE;
gd->bd->bi_memsize = CONFIG_SYS_MAX_RAM_SIZE;
- return CONFIG_SYS_MAX_RAM_SIZE;
+ return gd->bd->bi_memsize;
}